Electronics Forum | Fri Feb 25 16:16:01 EST 2005 | pjc
Here are some 5 zones models to look for: Electrovert OmniFlo5 Conceptronic HVA70 BTU VIP70 Vitronics SMR or XPM 520 Heller 1088 (4 zone)
Electronics Forum | Thu Aug 11 10:21:40 EDT 2005 | leonb
HI all, i have 2 omniflow 5 zone reflow ovens would these be suitable for rohs compliance also 2 iemme 760 reflow oven with 4 upper zone and 4 lower zones would these be suitable also any feed back would really help
Electronics Forum | Tue Feb 22 16:28:22 EST 2005 | Indy
Hi, Could anyone direct me Or let me know of a 5 zone (Used/Pre-owned) reflow oven that I could purchase. Thanks in advance cheers Indy
Electronics Forum | Wed Mar 30 17:32:55 EDT 2011 | gaz
Hi, We are using ws488 sn100c paste. Anyone have a profile for a 5 zone oven that has worked well for you?
Electronics Forum | Fri May 26 03:58:07 EDT 2006 | dave
Hi, We have a 5 zone oven and we use a RTS Profile. Our last zone is the zone that the reflow takes place. some basic analysis is as follows: TAL 70 secs, peak temp 210,ramp rate seems fine. A typical setting is : Z1 140 Z2 160 Z3 160 Z4 185 Z5 220
Electronics Forum | Wed Feb 23 18:27:12 EST 2005 | gpaelmo
Hi Indy, Check http://www.jmw-inc.com (they are in the midwest so shipping will not be too bad going out east). I bought 2 MPM printers and a pick and place machine from them late in 2004. I know they have 5-zone reflow and 7-zone ovens there (elect
Electronics Forum | Fri May 26 09:52:46 EDT 2006 | samir
Dave, For lead free, I've always left the ramp part the same and just spike higher in the reflow zone. I've also slowed things down a bit (5" per sec. slower)....without using prediction software, try, say... Z4 200 & Z5 260.
Electronics Forum | Tue Feb 22 22:29:47 EST 2005 | indy
G, I am in brooklyn, NY. Indy
Electronics Forum | Fri Feb 25 09:20:24 EST 2005 | pjc
Did you try looking on the Equipment Mart ? Its on the menu bar under Electronics Forum.
