Electronics Forum | Thu Aug 10 12:14:12 EDT 2000 | Charles
It looks like a giant dpak device but with 5 leads. The problem is that on approx 3% of our boards one more pins are open circuit. It appears that the pins are not in contact with the pads. Board is HASL finish IR oven Paste Koki 953i. If you have a
Electronics Forum | Fri Jun 15 11:05:17 EDT 2007 | grantp
Hi, This is a little embarrassing asking this question, as I think I am profiling our oven incorrectly. I have been using the profile based on the solder paste specification, however we have been getting a large BGA chip coming more unreliable, and
Electronics Forum | Mon Dec 06 03:54:57 EST 1999 | Chris May
Hi Russ, I have a similar situation. I have been told that this can be caused by the nickel, over which the gold is plated, can result in suspect joints, embrittlement etc. Some joints can even be weak and broken without much force on some of my boa
Electronics Forum | Sun Jul 26 05:56:28 EDT 2015 | spoiltforchoice
http://www.surfacemountprocess.com/solder-paste-printing-process.html this site has some pretty good general advice for the novice. I am in no way affiliated with it and I have no idea as to its eventual commerical aims (if any). ENIG if your produc
.png)
