Electronics Forum | Thu Aug 18 11:38:34 EDT 2011 | johndoe0222
I got this error message on the fuji IP3: " Servo limit over. Servo Z1 Axis +" I was wondering how to fix this error. Thanks.
Electronics Forum | Wed Nov 16 09:33:39 EST 2005 | SuMoTe
I can't help you with most of that, but heres a starting point. "L013: 2nd limit over" means that one of your axis is showing outside operating boundries, as in placement head is too far forward. Make sure all your devices are not pushed out to thie
Electronics Forum | Fri Feb 15 08:33:59 EST 2002 | fmonette
The joint IPC/JEDEC standard currently specifies a limit of one bake cycle, regardless of the temprature or duration. In the proposed revision this will be replaced by a maximum cumulative duration of 48 hours at 125C. The reason identified for thi
Electronics Forum | Tue Oct 14 10:52:35 EDT 2014 | swag
Can't help you with the manual but do have some tips: If it was shipped, it's possible someone tied axis or blocked stuff for shipping. Look for that. Look for bent sensor flags + go into I/O and check to see all sensors you can find are working.
Electronics Forum | Sat Oct 18 22:41:54 EDT 2014 | pfifla1
Can't help you with the manual but do have some > tips: If it was shipped, it's possible someone > tied axis or blocked stuff for shipping. Look > for that. Look for bent sensor flags + go into > I/O and check to see all sensors you can find a
Electronics Forum | Thu May 18 16:27:53 EDT 2006 | bman
I don't have any experinence with this, but my concern is that you are limiting the amount of contamination your pot can absorb before you ever run a board through. What I mean is that even if you are able to drain all but about a kg of the old sold
Electronics Forum | Thu May 13 09:47:32 EDT 2004 | Lubo
We are looking for a inspection system to check the positioning of a component over a PCB. We need it positioned both in X Y directions and height above PCB (it is a TH component) to be within certain limits. PLS advise can this be achived by AOI. Wh
Electronics Forum | Mon Jan 29 11:14:44 EST 2001 | medernach
Hi all, Here's the deal. I have a customer for whom I assemble a lot of product. All of their product mix goes through a water soluble process. Much of it gets conformal coated. They are in the high power arena but some products are simply contro
Electronics Forum | Fri Feb 19 11:13:02 EST 2016 | ttheis
I'm setting up a product for the first time on my GSM after I completed debugging some other issues. The previous owners had the PWC axis disabled and the axis motor disconnected, so I re-connected it and enabled it and now it homes and moves. When I
Electronics Forum | Fri Oct 28 14:09:39 EDT 2022 | ttheis
Allowing a part to go over the board boundaries can cause collisions when boards are nested. The software on these machines has limitations but it is plenty capable and rooted in preventing physical damage to the machine. Once you are familiar with t
