Electronics Forum | Wed Jan 17 22:28:35 EST 2024 | dwl
In the spirit of engineers not answering the question but providing an alternative solution, have you considered using adhesive labels? for very low volumes you can hand place them. for higher volumes, you can get them on reels and place them with th
Electronics Forum | Wed May 22 16:36:13 EDT 2002 | slthomas
What methods do you guys use for maintaining lot and/or board traceability? When I worked in med. products, we used travelers that we recorded everything on, then serialized them at the end of the build. Not as effective as up front serialization,
Electronics Forum | Sat Jun 08 13:16:06 EDT 2013 | unisoft
Take a look at the Unisoft software ( http://www.unisoft-cim.com ). For over 25 years this software has in use by Electronics Manufacturer CEM/EMS's and OEM's to automate New Product Introduction (NPI). It's perfect for Electronic Contract Manufact
Electronics Forum | Wed Jun 26 21:41:46 EDT 2002 | ianchan
Hi mate, "no more than 6hrs in the stencil" for us means: 1) we finish setup of reflow oven, P&P m/c, and lastly the printing machine(includes loading of stencil into printer machine). 2) once printer machine is setup, we rip-open the paste Can pr
Electronics Forum | Fri May 31 16:26:22 EDT 2002 | Feederman
Steve, you might want to check out the pre-printed and print-on-demand label feeders that are available through Hover-Davis. These types of feeder remove the potential human placement errors which sometimes occur. The feeders are available for most p
Electronics Forum | Fri Apr 20 14:11:27 EDT 2012 | rway
Programming is different, yes, but so is the terminology. ///with machine vision you have parameters that select what is good and what is bad, and you have parameters that help make bad look worse and good look better making the difference between w
Electronics Forum | Wed Aug 25 13:10:13 EDT 2004 | gregp
Stefan, The scenario you describe is the way it is done on our 3 series placement machines. The C5 series is a databased arrangement. Each reel (tube and tray) that comes in the door gets a unique ID (and a barcode label). This is done with the C5
Electronics Forum | Thu Jul 19 05:10:05 EDT 2007 | chrispy1963
If you have a adhesive application machine such as the Creative Automation machines we use on our SMT lines you could do as our company does. We pick a corner or an empty area on the board and apply a series of dots specifying the version you are bu
Electronics Forum | Thu Feb 05 08:39:35 EST 2004 | pjc
Dave is correct in that the Zevatech is actually a Juki. Made by the Japanese Juki and labeled by the Swiss Zevatech. The PM 575 is somewhat vintage. I believe it may be all mechanical component centering. It may be OK for the 20mil fine pitch but ma
Electronics Forum | Tue Aug 15 07:31:27 EDT 2006 | Chunks
Yes, when teaching fids and you get to the screen shows your fid (either board or stencil), hit the middle "roller button" labeled NEXT. This will toggle your bulb from regular to bright and vice/versa. If it's still very bright, the bulb itself ma
