Electronics Forum: lambda (Page 1 of 6)

Electrovert EPK plus wave lambda, chip sensor

Electronics Forum | Fri Apr 16 15:12:12 EDT 2021 | jsmith01

Does anyone know where the power to the lambda, chip sensors comes from on a Electrovert EPK plus? I have an intermediate issue with these sensors loosing power and the wave just keeps going higher and flows over the pot. I have replaced the senors

Nitrogen wave soldering

Electronics Forum | Thu Feb 13 08:28:47 EST 2003 | pjc

Call 1-800-737-8110 for tech support. They can give you the N2 supply specs for the 650C. You should consider the cost to convert the Contour to a standard Lambda vs. the cost to bring in N2 and the consumable costs. Tech Support can give you the ret

No solder and solder bridge after Wave solder machine

Electronics Forum | Thu Nov 17 20:51:16 EST 2005 | cangly

Morning Mike, We use Pb63/Sn37, Alpha Metal alloy. Solder pot is at 250 C. The profile of board after Preheat about 100 C, Lambda Wave about 220C (use both Lambda and Chip wave), DWell time 2.1s ~ 3s. Conveyor speed 1.5 in/min. We run by bare board a

Solder Skips and Shorts on Lambda Wave, Omega Upgrade?

Electronics Forum | Mon Aug 13 09:49:35 EDT 2012 | rjlatz

I just got back from a visit to our PCBA manufacturer. We have good flowthrough on the PTH, but solder skips and bridges on the SMT SO IC's. We have correct orientation and robber pads, but the results are still the same. I noticed the wave shape is

Describe term A wave

Electronics Forum | Sat Dec 12 17:46:35 EST 1998 | Tom B

SMTneters, I'm famialiar with lambda, omega, and gemini waves but not with "A" wave. Can somebody give me an explanation? thanks Tom B.

Nitrogen wave soldering

Electronics Forum | Thu Feb 20 00:51:42 EST 2003 | Joe

We are running an RMA flux (Kester 1515). Changing the angle didn't help any so we're back at 6 degrees and placing an order for the lambda nozzle changeover. Are you currently running the debridging knife?

Solder Wave

Electronics Forum | Fri Aug 12 03:38:32 EDT 2005 | md

Guys , Thanks for all your inputs on this one. I have had to increase preheats dramatically aswell as increasing conatct time over lambda wave. Joints are perfect. Cheers,

Solder balls

Electronics Forum | Wed May 09 11:25:29 EDT 2001 | medernach

What type of preheaters do you have on you're wave? I have to agree with Dave. Your leads are not cold, they are hotter than the annular ring on the PCB. This would cause the solder to go to the lead only rather than the component and land pad / a

Nitrogen wave soldering

Electronics Forum | Sat Feb 15 15:39:53 EST 2003 | Joe

I have the identical machine and setup as you with the same issue(s). I looked at setting up for N2 but am choosing to retrofit to a standard lambda nozzle setup. If you are soldering bottom side SMT parts or other challenging assemblies, N2 may ma

vitronics delta wave malfunction errors :pcb expected at exit

Electronics Forum | Fri Sep 14 03:43:16 EDT 2012 | mili

Hello!I have a delta wave with these problems:offtime of lambda wave tracking is too long and when modify offtime setting to a negative value for a fast stop on tracking position of lambda wave, the wave pass on stand-by with a delay of half of leg

  1 2 3 4 5 6 Next

lambda searches for Companies, Equipment, Machines, Suppliers & Information