Electronics Forum | Fri Nov 17 07:58:06 EST 2006 | markb
SWAG - I also forgot to mention a few things. Our delmaination was always between the large copper plane and the laminate. It is a multi-layered board, so even when the delamination appeared around components (through visual inspection), cross-sect
Electronics Forum | Fri Jun 01 16:13:45 EDT 2012 | kahrpr
You also need to get with the PCB manufacturer. Their is a lot that can go wrong with that many layers. If the manufacture is trapping that much moisture. you may have a hard time baking it out. Dave and Graham are right about the time and energy. It
Electronics Forum | Tue Oct 31 07:50:22 EST 2006 | markb
SWAG - Was your experiment on the board with the large ground plane? The board we are seeing issues with also has a large ground plane (approx 50% of PCB), and 90% of the delamination occurs in that area. The delamination is about the size of a sil
Electronics Forum | Thu Nov 16 11:45:15 EST 2006 | markb
I still think the best bet is probably an SMT pre-bake operation to ensure that there is no moisture in the board. Vapor pressure is usually the leading cause for delamination, so removing the source should significantly help out. Unfortuantely, pr
Electronics Forum | Tue Oct 31 09:43:06 EST 2006 | SWAG
Yes, this board is approx. 3" x 17" x .062"T with large areas of ground planes. However, the delam. does not seem to be confined to the plane. We also see it around component pads and fiducials. Generally speaking, it could be said that the first
Electronics Forum | Wed Nov 10 02:20:07 EST 1999 | Marc
The padsfor large heat sinks are being designed on our boards with large copper ground planes surrounding them by our engineers. I am having great difficulty keeping the reflow temperature below 230 degrees in order for the temperature of the copper
Electronics Forum | Mon May 14 22:24:11 EDT 2001 | davef
The time over liquidous of the profile seems short. But then again, who knows? Based on what you told us, I'm guessing at a board fabrication problem, either measling or delamination. Probably the former, rather than the latter. [Now, we remember
Electronics Forum | Tue Dec 28 21:51:04 EST 2004 | KEN
When using a foam fluxer: 1. Bubble size is important. What stones are you using? Ever clean them? Too large a bubble will NOT help your situation. (I forget bubble size range....check with your fluxer mfgr.) 2. Thinner will help in capilary m
Electronics Forum | Thu Jun 04 09:25:21 EDT 1998 | Chrys
| | | Hello: | | | BACKGROUD: SMT components soldered on the top-side of boards that also require wave soldering have the potential to reflow during wave soldering. Reflowing these components during wave soldering is not good. It can cause cold jo
Electronics Forum | Tue Jan 12 15:11:20 EST 1999 | Earl Moon
| | I have an Electrovert UPK 660c fitted with IR preheats top and bottom. We assemble a large range of multilayer backplanes and I was wondering if there are any advantages in changing to convection preheats.Has anybody got any views on the subject.
Buy and selling used smt，semi， Robot ,CNC and all used machines
Equipment Dealer / Broker / Auctions
DONGGUAN HUMEN
Dongguan, 30 China
Phone: 13560819457
