Electronics Forum | Wed Sep 08 15:59:25 EDT 2004 | kbayram
Hello, I'm looking for a lower end used machine that can place a 55x44mm sized bga component, placement speed is n't concern. At the moment I have only found the quad ivc to be capable although I'm worried about the placement accuracy and repeatabi
Electronics Forum | Tue Jan 15 10:17:36 EST 2013 | plaurine
Good Afternoon Everyone, I'm looking for a English speaking sales contact in SHENZHEN KAIFA TECHNOLOGY. I have tried calling the telephone number on the website with no success. I want to purchase a large number of boards they manufacture. Thanks
Electronics Forum | Fri Oct 27 09:10:34 EDT 2000 | jackofalltrades
We are very happy with Datum Dynamics (www.datumdynamics.com), good qualitiy and rapid turn around. They do our tooling plates, reflow pallets, selective wave pallets for a large number of varied customers.
Electronics Forum | Mon Apr 17 17:47:52 EDT 2006 | Brclyn
Orbotech is a machine best bought New - If you buy used - there is an $85K (negotiable)licensing fee to use the software and get service. The machine appears to be built well, but any company who effectively cuts out the "little guy" by throttling th
Electronics Forum | Fri May 12 01:55:29 EDT 2006 | AR
If you are not talking about a large number of BOMs, the cheapest way would probably be to do a CSV export of the BOMs and write an Excel macro in VBA to do the actual comparison.
Electronics Forum | Wed Oct 22 13:44:41 EDT 2014 | davef
Distributors have access to large number of connector suppliers * http://www.newyorkerelectronics.com/ * http://www.digikey.com/Connectors * http://www.newark.com * http://www.directindustry.com/industrial-manufacturer/card-edge-connector-93613.h
Electronics Forum | Thu Jul 18 11:26:08 EDT 2024 | dariaalexandrovna
Hello, As per me if your products have a large number of common components, a dual lane setup allows you to run different products simultaneously, maximizing efficiency and throughput. This setup can also provide flexibility in managing varying produ
Electronics Forum | Fri Sep 29 13:07:39 EDT 2000 | Stuart Adams
Can someone recommend a company that will X-Ray my boards and provide some analysis of the results ?? I just got a lot of assembled boards back with a large number of bad boards (after several sucessful runs by this assembly house) I am trying to f
Electronics Forum | Wed Jun 26 09:01:47 EDT 2002 | davef
Can�t see where �poly� would be any more �ESD friendly� than nylon. Explain that please. Consider: * Attaching tags with metal wire that has no insulation. * Contacting a factory sales rep that specializes in ESD protection and carries a large numb
Electronics Forum | Tue Jul 23 14:55:06 EDT 2002 | colnat
I am looking for defect rates on hand soldering. Specifically - I have a large number of wire jumpers that need to be hand soldered across two boards (connectors are not an option). I am looking for a defect rate so I can perform a cost analysis in