Electronics Forum | Wed Aug 04 16:43:58 EDT 1999 | John Thorup
| We are installing a new reflow oven and I have been told that we do not need to vent the exhaust out through the roof since we have a false ceiling. All that is required is to vent above the false ceiling and that the air exchange is great enough t
Electronics Forum | Mon Mar 22 15:05:52 EST 1999 | Scott
| | | | Looking for a company that makes a small batch reflow oven. Not a belt-style convection oven, but a cabinet style that can 125 c to 150 c. | | | | | | | | Thank you | | | | | | | TRY GE I HAVE ONE AT HOME THAT COOKES PRETY DARN GOOD. And i
Electronics Forum | Fri Dec 03 16:00:48 EST 2010 | glenseely
When faced with high mass, high cost, sensitive PCBs and now with the added challenges of Pb-Free Vapor Phase is the only safe reflow method for component and joint integrity. A-Tek is the National Distributor for Asscon Vapor phase reflow. Asscon
Electronics Forum | Wed Aug 28 18:08:07 EDT 2002 | MikeF
This looks like it may be a good application for an Air-Vac or Wenesco type solder station. It is a solder pot that has a small motor to pump solder up through a chimney. You can put different nozzles on the top of the chimney, so you only apply sold
Electronics Forum | Sat May 11 15:43:55 EDT 2013 | anvil1021
Hello Again...SMTNET....are there rules to determine which small BGA devices are Dip Fluxed or Solder pasted? What drives the decision? Obviously the device's pitch has a large bearing on this decision. Any and all comments or experiences would be ve
Electronics Forum | Tue May 15 17:24:52 EDT 2012 | jeremymek
Hi Before I say anything I ll qualify who I am. I work for a AOI/SPI manuafacturer Automatic printer is your best option for small runs. Print process is responsible for a vast number of solder defects and improving here is your best start. Have a
Electronics Forum | Wed May 16 01:06:38 EDT 2012 | bwjm
Hi Before I say anything I ll qualify who I am. I > work for a AOI/SPI manuafacturer > > Automatic > printer is your best option for small > runs. Print process is responsible for a vast > number of solder defects and improving here is > your b
Electronics Forum | Sun Jan 29 14:10:14 EST 2006 | gipos
Hi GS, We are contract manufacturer for small series of electronic equipment fully trained for SMT.Making mostly RF with only few QFPs,TSOPs...SMT machine assembly was made by local subcontractor when needed. Recently we acquired two Juki 730 machin
Electronics Forum | Mon Oct 24 18:48:23 EDT 2005 | GS
Thanks Gents for your replies, first of all I am not involved in production or sale of those tools. It was just a discussion during one of those so many "panic full" work shops / symposiums on WEEE and ROHS matter organized by material or SMT equip
Electronics Forum | Wed Dec 10 16:14:37 EST 2014 | jimpat
The 300 degrees is the temperature as measured at the sensor. The actual air temperature just above your PCB may actually be much less. If the oven is properly calibrated then the 300 should represent air temperature at the board but I have seen ma
