Electronics Forum | Fri Apr 12 10:15:12 EDT 2002 | dima
Hi! I investigate possibility of manufacturing laser cut stencils. May be someone knows about equipment suppliers for such production (lasers, e.c.t.)? Thank you in advance for your help!
Electronics Forum | Sat Apr 13 12:54:39 EDT 2002 | dima
Thank you Dave! Very usefull information, very detailed. Thanks once again! Dmitry
Electronics Forum | Fri Apr 12 17:19:34 EDT 2002 | davef
Some suppliers of stencil cutting machines are: * Lumonics, 130 Lombard St, Oxnard, CA 93030 805.485.5559 fax3335 http://www.lumonics.com * Directed Light 633 River Oaks Pkwy San Jose, CA 95134 800-468-2326 408-321-8500 fax 8466 http://www.directed
Electronics Forum | Sun Apr 14 14:13:25 EDT 2002 | davef
I assume you're looking at stencil fab equipment because you need 'faster turns' than you can get from available stencil suppliers. While you're assessing this, consider other alternatives, such as: * Dispensing paste. [A very funny SMTNetter, livin
Electronics Forum | Fri May 11 03:55:22 EDT 2007 | lupo
Hi everybody, Please could anyone shed any light on the subject: resistance laser cutting with flux- calibration of LEDs during electronic assembly phase. Should special equipments be used? What is exactly the process? Thanks and Regards,
Electronics Forum | Fri May 11 10:48:51 EDT 2007 | Rob
Hi Lupo, Are you talking about laser trimming the current limiting resistors in front of the LEDs, whilst dynamically measuring their output to get set light levels? If so then you need a laser trimmer & a very good photodiode/comparator feedback l
Electronics Forum | Mon Jul 12 11:11:25 EDT 2004 | Stefan
For laser marking you don�t require as powerful lasers then for cutting. A 20 Watt laser diode does already a good job. Because of the safety requirements the laser operates in an enclosure, which means more $$$ if you want to use the laser in line
Electronics Forum | Wed Dec 17 08:47:18 EST 2014 | cloughley
What are the added capabilites going from 7w to 20w, 355nm YAG laser I wanted to know what the added capabilities we now have are going from a 7w to 20w, 355nm YAG laser. Currently we support the following materials: http://www.bestlaser.net/mater
Electronics Forum | Thu May 01 23:32:46 EDT 2014 | asajedi
I have assembled panels of 24"X9.5" LED Panels (24 strips of 10mm). I need to cut them into strips and join them together then add double sided 3M tape and spool them. How is this best accomplished. Laser Cutting, Die Cutting, Roller Cutting
Electronics Forum | Sun Oct 09 01:11:34 EDT 2005 | vev
There is a stencil cutting machine in the industry which utilizes a water jet to deliver a Laser beam for cutting stencils. There are no machines of this type in the states. The quality is no better than a Laser cut stencil using a good Laser System.