Electronics Forum | Thu Jun 28 09:11:19 EDT 2012 | davef
I though this was a good article on picking a part numbering scheme and since you weren't getting any takes figured I throw this out there and maybe get a conversation going. Part number system: How to get started Filed under: Item and File Man
Electronics Forum | Thu May 26 15:13:47 EDT 2016 | bobpan
If there is dust (on the glass) off from the center of the lens it will add it to the part when scanning it and place off. I have ran into this twice.....I fixed it once by breaking the lens on the quad align and blowing it out.....another time I hel
Electronics Forum | Thu May 26 15:16:28 EDT 2016 | bobpan
oh ya....i forgot....to verify this....turn off all the extents for the parts and just pick them and place them....if they are very close to where they should be then it is the quad align causing the problem....this is how you can verify it. Copy the
Electronics Forum | Wed May 25 22:32:28 EDT 2016 | stevedc
So, I haven't used my Quad 4C for a while and when I started everything back up to run a new board it appears that the Quad align is in need of calibration. When I pick up a component and do an LAE measurement on it it shows the part center location
Electronics Forum | Mon Oct 15 12:13:00 EDT 2012 | lkavan
Hallo friends, I am looking for interface board for Tenryu MT5530. Its name is DIF3-1. If you want, I can offer servo drivers or some pneumatic feeders for change. Thank you for help.
Electronics Forum | Thu Mar 15 12:36:04 EDT 2018 | deanm
Is the nozzle in good condition? If it is not flat because of damage or wear, it might loose vacuum and the part may have a tendency to shift. I don't have experience with these machines but how do you know the spindle is spinning slower when the co
Electronics Forum | Thu Mar 15 18:18:36 EDT 2018 | maustin
Yep, checked the nozzle (that was my first port of call). Had a look at it under our microscope, and also swapped it out for another nozzle to be sure. The problem still exists. You can set the theta speed, but only to Fast, Medium or Slow. I've
Electronics Forum | Thu Mar 15 18:21:26 EDT 2018 | maustin
Cheers. I have a suspicion its an error with whatever part of the machine measures shaft rotation, but the grub screw thing is an easy one to check and eliminate. I'm only guessing from what I can see, but it looks like its setting the component at
Electronics Forum | Thu Mar 15 18:15:28 EDT 2018 | maustin
The 740 has been a great machine for us. We've been able to reliably load components as small as 0603 (we've not tried 0402, but I believe with a special nozzle adaptor, you can get it to work) and place a 7x7 56 pin QFN with 0.4mm pin pitch with hi
Electronics Forum | Wed May 19 09:32:28 EDT 2004 | Mr Fix it - MPM
Sounds to me like the driver for the tactile is not working. The tactile has three components to it. The first is the switch, the second is the pneumatic up/down actuator and the third is a small motor in the tactile assembly. The motor has a driv
