Electronics Forum | Wed Dec 13 19:40:38 EST 2000 | Jerry Wetzel, SME, EM/SME
Your profile must be precise, your stencil aperture sizes and shapes are very important, and the size of the pads on the boards should be very close to what the part manufacturer recommends. We had some trouble with hi-temp paste, and discovered tha
Electronics Forum | Sun Dec 26 16:13:49 EST 2010 | sam
Hi, Here is a brief synopsis of PNC - PNC has been a quality manufacturer of rigid printed circuit boards for 40 years. Located in Nutley, NJ, we are the largest shop in the North East. PNC provides complete turnkey jobs from design, PCB fabricatio
Electronics Forum | Wed Feb 25 08:34:00 EST 1998 | Earl Moon
CERAMIC CIRCUITRY Starting with hybrid thick film circuits in 1965 at Sperry Flight Systems, I have been involved with ceramics (usually aluminum oxide) as the substrate material. Then, we developed "multilayer" circuitry (replacing "cordwood" module
Electronics Forum | Wed Feb 25 08:30:44 EST 1998 | Earl Moon
| Happy Holidays All, | I am searching out a vendor (US preferred) who can fabricate a ceramic PCb with etremely fine lines. | Please reply if you are a vendor, or know of one. | Thanks, | Wendy CERAMIC CIRCUITRY Starting with hybrid thick film circ
Products, services, training & consulting for the assembly, rework & repair of electronic assemblies. BGA process experts. Manufacturers Rep, Distributor & Service Provider for Seamark/Zhuomao and Shuttle Star BGA Rework Stations.
Training Provider / Manufacturer's Representative / Equipment Dealer / Broker / Auctions / Consultant / Service Provider
1750 Mitchell Ave.
Oroville, CA USA
Phone: (888) 406-2830