Electronics Forum | Sat Apr 03 16:39:15 EST 2004 | stefwitt
We had a similar system on the Siemens machines, quite some time ago. However, it was not a laser light but a LED and a fiber cable. Actually the center fiber or receiver was surrounded by a bundle of small fibers for the LED light source. You may al
Electronics Forum | Fri Apr 02 09:50:40 EST 2004 | cedams
Yup. It was definitely checking the fiducials as well as the block skip marks and it used to work pretty well. What it did was started at the center of where the fiducial should be and scanned left. When it found a change in contrast it scanned righ
Electronics Forum | Fri Apr 02 16:45:29 EST 2004 | cedams
Ken, You'd think so but the tooling pins only register to the drilling process for the PCB. The fiducial registers to the copper pattern and for both glueing and placing SMT components the pads are more important than the holes. That's why the machi
Electronics Forum | Mon Apr 12 09:39:38 EDT 2004 | cedams
Ken, Thanks for the feedback. Unfortunately (or fortunately) I am in Mexico and we make our own PCBs. That is another conversation entirely and another of my fix-it projects but currently we drill the PCBs and align the artwork to the holes visually
Electronics Forum | Thu Sep 14 06:18:00 EDT 2023 | deniseburton
Hello, mcdvoice It seems like your Juki RS-1R machine's laser height calibration may be off. When measuring a 0402 resistor, it consistently reports heights around -0.60 to -0.70, causing pickup issues during production. Manually adjusting it to -
Electronics Forum | Thu Mar 15 17:50:18 EDT 2018 | sarason
Possibly a loose grub screw on one of the shafts controlling rotation or the sensor ot gray code wheel on the rotation servo motor. or even a small fault in the program eprom, Good luck sarason
Electronics Forum | Wed Feb 11 11:12:23 EST 2015 | daniel_esposito
Thank you Bobpan! I checked the laser sensor and could see through the glass a small stripe (dash)in the inside lens, just in the middle of it. Thank you again.
Electronics Forum | Wed Feb 11 08:33:25 EST 2015 | daniel_esposito
Hi, I have two Quad IVc and both of them have the same problem. Laser Alignment is not working! When I run funtion 30, it always gives 1 at nozzle height. If I place any object beside the nozzle, it will give a number different from one depend on how
Electronics Forum | Mon Nov 06 21:02:45 EST 2017 | dlerkin
Hi, I'm looking for a software copy for the CyberOptics Cyberscan Cobra Laser Profile Scanner. An issue with one of the files is preventing the software from running and we no longer have the original copy to re-install it on our computer. This Cyber
Electronics Forum | Fri Apr 04 16:56:50 EST 2003 | RicardoF
Thankyou Stefan, somehow the Laser sensor and controller are addresed to the IP, but it seems the results are simple as an OK or some codes when the part is out of specs, those codes appears on the monitor in the machine just for a while, likely the
Industrial Sensor Vision International specializes in advanced camera technology of high resolution fast speed cameras for automation, AOI, 2-D/3-D, SPI inspection and wafer inspection.
3 Morse Road 2A
Oxford, CT USA
Phone: +1 203 592 8723
winsouce.jpg)
.gif)
