Electronics Forum | Thu Sep 02 05:12:15 EDT 2004 | doi
I am using a triad connector and have problem with wetting at both connector latches.Observed that the leads have very good shiny wetting however concerning the latches the solder just seem to disappear to thin airafter reflow.The connector has a gui
Electronics Forum | Thu Sep 02 09:51:53 EDT 2004 | davef
We see latches from some suppliers that just are not solderable. Usually the nickel plate on the latch is poor, allowing the nickel to corrode, and requiring a more active flux [if you're lucky]. But lots of times, you end-up with partial wetting,
Electronics Forum | Fri Sep 03 04:04:19 EDT 2004 | doi
Thanks davef for a your insights :)
Electronics Forum | Fri Sep 03 08:25:30 EDT 2010 | remullis
I removed the muffler yesterday and still had the latch releasing issue, the latch was tight, however the table had some play in it. I adjusted the play out of the table, setup table zero and it fixed the problem. Same symptom as if the latch were lo
Electronics Forum | Fri Jan 19 08:10:03 EST 2018 | emeto
It should be one of these latches that got stuck in position. I had a similar problem(my200 machine) the other way around - my stays closed so I don't get any vacuum. The problem is that the whole block of latches should be replaced(on a my200 machin
Electronics Forum | Tue Apr 02 17:22:50 EDT 2013 | microaide
That makes some sense. By knowing the coordinates of the leftmost and rightmost feeder, the others can be interpolated. As long as they are all the same type of feeder. But I still don't see how to configure an assortment of different types of vibrat
Electronics Forum | Tue Apr 19 21:23:37 EDT 2022 | kumarb
Hi. On our YV88X (Emerald-X), we use the edge clamp + Push-IN clamp to secure the PCB. The push-in metal part pops up fine but unable to move this piece to the LEFT or RIGHT using the dial inside the machine. The latch inside the machine is rotated '
Electronics Forum | Fri May 22 07:32:32 EDT 1998 | Martin Plourde
Hi, I am presently searching for 10 latching 8 mm feeders for a Quad 100. Please get back to me with pricing if you have some. Regards, Martin Plourde Selectron Inc. (514) 326-5261
Electronics Forum | Mon Dec 06 21:41:13 EST 2004 | pdeuel
I have the same problem but an MPM downstream of the Fuji. Im looking for schematics for this Fuji. Before we had another machine hooked to this Fuji and the output switch needed to be set to latch. Otherwise only a pulse was seen and it was not long
Electronics Forum | Sat Mar 26 14:21:01 EST 2005 | andras
My CSM pop-ups this error after power on: 243 X DRIFT ADJUSTMENT NO GOOD and then latch-up. How can I solve this problem?
