Electronics Forum | Mon Nov 09 16:55:33 EST 1998 | Doug Clement
I have a need to dispense a latex masking material using an automated dispensing system. We are presently looking at the I&J750. Does anyone have any experience with this piece of equipment, or have a better solution available?
Electronics Forum | Tue Nov 10 12:47:06 EST 1998 | Dave F
| I have a need to dispense a latex masking material using an automated dispensing system. We are presently looking at the I&J750. Does anyone have any experience with this piece of equipment, or have a better solution available? | Doug: Fisnar m
Electronics Forum | Thu Nov 12 10:05:05 EST 1998 | Doug Clement
| | I have a need to dispense a latex masking material using an automated dispensing system. We are presently looking at the I&J750. Does anyone have any experience with this piece of equipment, or have a better solution available? | | | Doug: Fi
Electronics Forum | Wed Nov 11 08:37:46 EST 1998 | Wayne Bracy
| I have a need to dispense a latex masking material using an automated dispensing system. We are presently looking at the I&J750. Does anyone have any experience with this piece of equipment, or have a better solution available? | Doug: You mig
Electronics Forum | Thu Nov 12 11:16:55 EST 1998 | Dave F
| | | I have a need to dispense a latex masking material using an automated dispensing system. We are presently looking at the I&J750. Does anyone have any experience with this piece of equipment, or have a better solution available? | | | | | Dou
Electronics Forum | Fri Nov 13 10:25:11 EST 1998 | Doug Clement
| | | | I have a need to dispense a latex masking material using an automated dispensing system. We are presently looking at the I&J750. Does anyone have any experience with this piece of equipment, or have a better solution available? | | | | | |
Electronics Forum | Mon Aug 21 09:11:30 EDT 2000 | Eric Soderberg
Currently use Hysol TS300 latex mask and need to explore alternative methods of drying the mask. The mask is applied with a Asymtek Century Dispenser and placed on drying shelves. Air dry is dependent on temperature/humidity. Tried all the UV masks o
Electronics Forum | Mon Aug 21 19:38:33 EDT 2000 | Dave F
Eric: I�ll pass on the uV and ammonia, also. Thoughts are: 1 You�re correct that the temperature/humidity mix can be a big driver to latex peelable solder mask cure time, but don�t overlook material thickness. Dispensers put material in a very th
Electronics Forum | Fri May 15 19:08:25 EDT 2009 | jlawson
Ammonia based masks can create solderability issues after they are removed. You can get non-ammonia based latex mask material but down side is slower cure and cost a little more as they have higher levels of latex etc
Electronics Forum | Sat Sep 18 12:10:19 EDT 2004 | Steve Gregory
I have a question about solder masking via's in a BGA pattern, and want to see if I'm thinking correctly about this. This problem is kind of along the same line as Carol's problem earlier. I think it's a bad idea to leave the via's free from solder
