Electronics Forum | Tue Nov 01 14:38:45 EDT 2022 | glasscake
Did the tray changer use to work on this machine? was it ever disabled and uncoupled from the machine? If you have an old data disk or backup disk of the machine try restoring to that. There is also a jumper inside the wiring harness to include the
Electronics Forum | Mon May 07 22:25:21 EDT 2001 | Doug Kester
Has anyone heard of a single or double tray holder plate for Siemens Siplace equipment (either OEM or aftermarket). This would be similar to the Universal, Quad, and Zevatech platens for trays that just clip on to the feeder holders. Have only a co
Electronics Forum | Tue May 08 08:26:15 EDT 2001 | caldon
Yes Siemens has a fixed tray feeder for matrix trays. If I remember correctly the tray will occupy 1/2 of the table.The feeder is a two part system 1) is the base 2) the the flat tray (just like what is used in the waffle pack changer). the flat tray
Electronics Forum | Mon May 14 15:20:35 EDT 2001 | stefwitt
You can make up a plate over lapping the tape exit guide and to the right up to the nozzle changer. It should hold three standard size Jedec trays. I used the bases of two old vibratory feeder. No matter what you do, you should use strong magnets to
Electronics Forum | Fri Jun 20 13:09:42 EDT 2008 | jim5926
Yes we are operating two SM 421 with side tray changer and they are great machines. We have had no trouble with them and the service from Dynatech has been great.
Electronics Forum | Thu Aug 21 15:30:28 EDT 2008 | jamyboy
Juki is a great way to go as far as reliability the Jukis are bullet proof. Change overs are much like other Japanese machines if you have the feeder carts, tray changer and stay away from Vibratory feeders you will be successful with this platform i
Electronics Forum | Mon Feb 27 10:12:51 EST 2012 | acsscott
OK, Used specialist to enter the machine config at power up. We don't have a Tray Changer option listed.
Electronics Forum | Tue Jan 23 10:57:54 EST 2001 | mdaley
Hello, I'm currently in the process of determining the best way to place bare die (flip chip) on our substrates. I've seen the Hover-Davis DDF and was impressed by it's capabilities. I particularly like the fact that I won't incur the cost of packa
Electronics Forum | Sat Sep 05 16:09:10 EDT 2015 | emanuel
Need assistance - I want to disconnect an unused LCS module from an Emerald machine. I disabled the tray changer and buffer conveyor in the machine's configuration but I still get an L212 error on the bottom of the screen and the machine hangs during
Electronics Forum | Tue May 06 11:14:40 EDT 2003 | k_h
Sorry, I did misunderstand. My opinion would be: Assuming nothing else used feeder space, like tray changers, camera's, nozzles, ..... and assuming 1 slot = 1 8mm feeder position, I think 70-90 slots would be reasonable. A reasonably priced feeder ta
