Electronics Forum | Tue Nov 30 17:00:26 EST 1999 | Dave F
Listed in the archive are suppliers of lead forming equipment. Most have equipment that can do the stand-ups you require. Yes you may be able to find this used. Yes you may be able to find someone with that machine near you who after you buy the t
Electronics Forum | Tue Mar 05 11:07:17 EST 2019 | sumote
Looking to purchase a DIP lead forming tool. The tool that has the 2 rollers that let you place the DIP part on the rail and run it between 2 rollers (ball-bearing?). I found a place that once sold them. They were called an RS Pro IC Insertion Tool
Electronics Forum | Tue Jul 13 14:36:55 EDT 1999 | JohnW
| I am examining cut & form PTH component prep equipment to help in our manual PTH insertion process. We need the ability to process both axial & radial with snap-in and stand-off capability. Low volume with the ability to feed bulk, T&R, or Stick. |
Electronics Forum | Wed Jul 14 19:09:54 EDT 1999 | JohnW
| | | I am examining cut & form PTH component prep equipment to help in our manual PTH insertion process. We need the ability to process both axial & radial with snap-in and stand-off capability. Low volume with the ability to feed bulk, T&R, or Stic
Electronics Forum | Wed Jul 14 09:26:55 EDT 1999 | Dave F
| | I am examining cut & form PTH component prep equipment to help in our manual PTH insertion process. We need the ability to process both axial & radial with snap-in and stand-off capability. Low volume with the ability to feed bulk, T&R, or Stick.
Electronics Forum | Sat Sep 01 10:46:22 EDT 2012 | davef
Years ago, we almost bought a Manix axial lead former / trimmer, but found a used Hepco at the last hour and went that route. I can't remember, but as I recall, we wanted to be able to do standoffs and there was some issue on standoff tooling with on
Electronics Forum | Wed Jul 14 09:56:54 EDT 1999 | Wolfgang Busko
| | I am examining cut & form PTH component prep equipment to help in our manual PTH insertion process. We need the ability to process both axial & radial with snap-in and stand-off capability. Low volume with the ability to feed bulk, T&R, or Stick.
Electronics Forum | Thu Jun 09 20:48:07 EDT 2016 | deanm
I'm assuming these are two leaded axial components. GPD Global makes fluid dispensing and component prep equipment. Component leads can be formed (or bent) in order to provide some resistance in the hole during insertion. This should prevent the comp
Electronics Forum | Tue Jul 19 09:06:00 EDT 2016 | davef
We used to use those, back in the bad old times. basically, it's a router with a blade on it that is used to trim the leads of PTH components that are mounted on boards. Nasty process. Difficult to control. Messy, firing cut leads all over the plac
Electronics Forum | Mon Jun 07 12:22:44 EDT 1999 | Chrys Shea
| I'm encountering a new problem at my new company that I haven't encountered before in my past life - and that's Wave Soldering VIA holes. | | We've been getting a rash of defects that we call in this company, "insufficient solder in VIA hole." The
| 1 |
