Electronics Forum | Sat Nov 21 12:22:00 EST 2009 | patrickbruneel
You are technically correct eutectic Sn/Pb was discovered by the ancient Egyptians in (XXX) BC much longer then 20 centuries. I was just referring to soft soldering in the electronics assembly industry :-).
Electronics Forum | Thu Nov 20 17:58:55 EST 2014 | joe98375
here it is: http://www.pcbunlimited.com/ben-z-400-f-lead-free-wave-solder-p-556.html
Electronics Forum | Wed Jun 15 13:49:56 EDT 2005 | russ
Been loading lead free (steel, bismuth) for a couple of yrs. now. Our Wildlife division went ROHS on the waterfowl hunting some time ago. So now we just wound geese and ducks and let them die somewhere that they are of no use except coyote food!
Electronics Forum | Tue Jul 12 00:13:39 EDT 2005 | fctassembly
Sorry to contradict your suggestion but the Asahi 300 series alloys contain indium which is both very expensive and has very limited availability.
Electronics Forum | Wed Nov 02 10:45:40 EST 2005 | michael
Bob Gilbert, could you pls email me the reliability data for joints made with SN00C and SAC305 alloy. my email: michael_wkk@263.net
Electronics Forum | Thu Nov 19 20:05:14 EST 2009 | davef
Density. There is a difference between lead (.410 lbs. per cubic inch) and tin (.254 lbs. per cubic inch). The same volume of tin-based solder, therefore, weighs approximately 1/4 less than a lead-based material. This adds up to more joints per pound
Electronics Forum | Thu Sep 08 06:19:55 EDT 2005 | lupo
Hello, Could anyone provide some support concern issue with vertical fill of through hole solder. Our lead free wave soldering process is not capable to fill 100% (requirement of our customer)through hole. We made everything (DoE) - different amoun
Electronics Forum | Wed Sep 10 16:53:46 EDT 2008 | realchunks
Actually it's not rare. I use several pastes from various manufacturers that add 2% silver in their leaded pastes. I would bet it's 2% silver.
Electronics Forum | Mon May 16 18:03:30 EDT 2005 | davef
Key Issue: Will this machine solder your boards? You never know until you solder one. Any other avenues of analysis involve substantial risk. Flux Selection * High or low solids * VOC or VOC-free Solder Alloy * If using lead-free, avoid stainles
Electronics Forum | Thu Aug 08 11:58:25 EDT 2013 | rway
I am not that familiar with the older systems. The software should be supported on both old and new alike unless you are limited by the operating system, but the camera will obviously have a lower resolution and perhaps the filtering is not quite as