Electronics Forum | Sun Sep 23 18:59:59 EDT 2007 | darby
I presume you are looking at low melting point solders. Firstly, I would consider running BOTH sides with the same paste - this will cut down the opportunities for a mix up with rework or retro-fit. Secondly, check that there is a cored wire availabl
Electronics Forum | Tue Sep 11 22:40:26 EDT 2007 | philip_yam
We are testing SAC paste for thru-hole components in the 2nd reflow process. The solder joint is alright but some problem encountered in FR1 or CAM2 PCB after multiple times of reflow due to the temperature. We are very interested in Zn or Bi-based l
Electronics Forum | Thu Sep 13 22:06:02 EDT 2007 | davef
While you're waiting for others to respond, here's one take on bismuth in lead-free soldering [ http://smt.pennnet.com/Articles/Article_Display.cfm?Section=Articles⊂section=Display&ARTICLE_ID=229915 ] by a long term friend of SMTnet. Find more by sea
Electronics Forum | Mon Jul 16 10:17:22 EDT 2007 | realchunks
Yes you can use no-lead parts in a leaded process. Your solder joints will be weaker than they once were unless you change your solder paste. You can try to improve this by running a hotter reflow temp, but be careful since your flux was not design
Electronics Forum | Mon Jul 16 10:51:09 EDT 2007 | patrickbruneel
D. Hillman, et al., �The Impact of Reflowing a Pb free Solder Alloy Using a Tin/Lead Solder Alloy Reflow Profile on Solder Joint Integrity,� International Conference on Lead-free Soldering, CMAP, Toronto, Ontario, Canada, May 24-26, 2005, http://www.
Electronics Forum | Thu Jul 19 04:38:33 EDT 2007 | chrispy1963
I took a Lead Free troubleshooting Class at SMTA in Chicago last September taught by Phil Zarrow. He told us during that seminar that its not a good practice to cross contaminate Leaded and Lead Free components but IF it is necesary than using lead
Electronics Forum | Thu Jul 20 13:01:07 EDT 2000 | qsheng
What is the difference of formulation No-Clean Sn63 with No-Clean lead free paste? Is there techniocal data in detail for performance property of No-Clean lead free paste (for example, viscosity, solderability, tack, print life, reflow profile)? Is
Electronics Forum | Tue Oct 21 23:28:59 EDT 2003 | xz xiao
We all know the Lead Free process is trend, so we trial run it, now it is only my comment that we have a good achievement after several tries,we have taken serveral photos about Lead Free process with ErsaScope. 1.The surface of the solder joint are
Electronics Forum | Tue Oct 21 23:29:08 EDT 2003 | xz xiao
We all know the Lead Free process is trend, so we trial run it, now it is only my comment that we have a good achievement after several tries,we have taken serveral photos about Lead Free process with ErsaScope. 1.The surface of the solder joint are
Electronics Forum | Fri Dec 08 21:23:16 EST 2006 | Harsha
I am seeing a problem of flux droping on the PCBA during reflow. This is a pb free process and I am using KOKI pb free paste with 8 zone (and some 9 zone) reflow ovens. Line throughput is about 10,000 boards/24 hours. I suspect that the exhaust is no
