Electronics Forum | Thu Apr 23 18:40:35 EDT 2009 | nickh
Do any of you fine people have any suggestions on how to align the Fuji CP3 tape leaf sensor? The little mirrors are out of alignment, any ideas how to get them back? Thanks!
Electronics Forum | Sat Apr 25 02:46:18 EDT 2009 | smellew
FYI SME offers a replacement Tape leaf detection system which covers the whole range of FUJI CP4-CP7 machines.its also very reasonably priced. It doesn't use Fibre Sensors or mirrors. it only has 1 adjustment which is height via Eccentric screw. even
Electronics Forum | Mon Apr 27 11:04:59 EDT 2009 | nickh
Thanks for the help Jerry
Electronics Forum | Wed Jun 10 01:33:20 EDT 2015 | leeg
Are the leaf springs in good order and set right? If they are then it could be calibration related.
Electronics Forum | Fri Feb 13 10:13:56 EST 1998 | Simon Washer
Has anyone running the cp4-3 feeders (MC type) in 8 by 4 td flavour seen excessive wear on the aluminum body caused by the tape leaf cover and tape leaf retaining clip?? These are the black anodised aluminum feeders (new type) that we run on all cp4
Electronics Forum | Fri Jun 16 15:50:08 EDT 2006 | Bert van den Berg
PSA - Pressure Sensitive Adhesive? I don't know which type of tape the affected reels of parts use but it is not sticky. Thanks everyone for the comments and suggestions. There were no missing teeth on the plastic take-up reels. I have cleaned an
Electronics Forum | Mon Oct 22 10:54:48 EDT 2007 | mulder0990
What type of feeder storage carts do you use for your feeders? I have many of the Fuji CP-6 racks, but I have found the few Mossman Tebbs racks mor useful and safer for the feeders. I am constantly fixing damaged tape leaf covers from operators not
Electronics Forum | Thu Mar 01 16:39:29 EST 2012 | triadelectronics
Our company is going to attempt to place 0201 components using our Fuji CP4-3 with the upgraded SMD3 vision system. Count On Tools is providing the 0.4 mm nozzles and we are using our 8mmX2mm feeders with the 0.7mm tape leaf (if it works at all we w
Electronics Forum | Thu May 20 01:53:31 EDT 2004 | alwil
I repair our Fuji feeders myself. They are easy to work on. Most of the issues are usually related to components jammed and general cleaning. Minimum lubrication is required. Tape leafs are inexpensive to replace too. Happy repairing. Cheers.
Electronics Forum | Thu Jan 18 14:34:50 EST 2007 | wrongway
If the show would of been in san diego again this year im sure we would of had 3 or 4 guys go but since its in L. A. nobody is going from our shop. I heard if you turn the wrong way leafing the show it gets bad real quick
winsouce.jpg)
