Electronics Forum | Thu Sep 03 10:13:38 EDT 2009 | markgray
Our wave started leaking a year ago. We welded, patched inside and outside the pot with metal patch. This works if you leave your wave on all of the time. If you turn your pot on and off consantly, the temperature cycles will bring the crack back. Ty
Electronics Forum | Wed Apr 15 09:59:56 EDT 1998 | Miangui Xue
I have a hermetic package with 1 atm of Helium (5% vol.) and Argon (95%) inside. We have detected the helium leaks at 5*e-8 ccatm/sec. My question is what is the leaking rate of argon. Can anybody provide any insight or information to calculate the r
Electronics Forum | Wed Sep 02 16:02:25 EDT 2009 | proy
Any suggestions/experience in repairing an old electrovert stainless wave solder pot? We have been running SN100C in this pot for a few years, and it developed a small leak along the weld in one corner. I am wondering of the best repair methods, an
Electronics Forum | Sun Nov 10 09:58:38 EST 2013 | kumuda
We have been using a circuit board in the assembly of HV Tank used in X-ray generator. This board acts as a sealant to the oil tank opening. The top side area of the board which comes in contact with oil is conformal coated to avoid oil leak. However
Electronics Forum | Thu Jan 26 14:36:16 EST 2012 | carvincorp
Thanks for the replies. We have purchased a spare frame so if it happens again, we won't be stuck waiting for a repair. Good info about the burr that was causing a repeat leak- I will keep that in mind if it happens again.
Electronics Forum | Tue Jan 10 19:01:13 EST 2012 | carvincorp
I was wondering if anyone else out there using the Vectorguard system by DEK has had problems with leaking air bladders. We started using a 29 x 29 frame about a year ago, and already, we've needed to send the frame back 3 times for repair due to int
Electronics Forum | Wed Feb 15 11:39:58 EST 2012 | cyber_wolf
Spend the extra 10 dollars and buy space saver frames. Problem solved.
Electronics Forum | Thu Sep 15 12:28:00 EDT 2016 | cyber_wolf
Like maybe the two supply lines to the module are flip flopped. Ive seen this cause issues.
Electronics Forum | Mon Sep 19 10:24:00 EDT 2016 | emeto
How about the rubbers on your picture? what are they doing there? Any broken or deformed?
Electronics Forum | Fri Dec 21 18:44:23 EST 2018 | ramsus
hello I chose to change the wet cleaning paper and dry paper with wet cleaning mode activation but I have a solvent leakage problem (solvent leak alarm) I detected a leak at the level of cleaner. can you get an idea about this problem and can help m
winsouce.jpg)
