Electronics Forum | Thu Jan 06 10:56:32 EST 2005 | Rob
If the Leds are not in close proximity then LDR's can be used connected to a node on the ICT/wired into a micro for a simpler board - you can then test for luminous intensity as well as absence. Else you could use a cheap CCD camera with some simple
Electronics Forum | Wed May 15 05:44:04 EDT 2019 | peterchan
1、YSVJ-650B three-group multi- blades cutting machine, multiple sets of tools run at the same time, split the whole piece at one time, greatly improve production efficiency; multiple sets of tool design ensure that the split plate effect is not defor
Electronics Forum | Tue Dec 29 11:33:40 EST 2015 | g2garyg2
PROMATION has recently installed several production lines this year for 48 inch long LED PCB panel production. There are solutions available from Screen Printing, Pick and Place, AOI, as well as a full line of handling solutions. www.PROMATIONUSA.com
Electronics Forum | Mon Dec 21 10:14:53 EST 2015 | jax
Many Manufacturers make Large board capable machines. A quick way to find them is to look for LED machines, the lengths should range from 32" to 52", although some simply manipulate the staging (clamping) area to achieve length. The trick is finding
Electronics Forum | Mon Jan 30 10:01:07 EST 2017 | smduke
Hello and thanks in advance. I am new to this stuff, I bought a wireless transmitter receiver and am wondering how to connect the power source, a buzzer to the receiver and a led light to the receiver. attached is a screen shot of what I have and wh
Electronics Forum | Mon May 31 09:47:57 EDT 2021 | fujipro
Sorry, no chance to check the IPS on AHC without the necessary Jigs and the knowledge. 7F12 is typical errorcode for a poorly connected Ribbon cable on the LED Board. If this error still occurs after reconnected the LED Board is may broken. If needed
Electronics Forum | Fri Jan 25 10:15:56 EST 2019 | babe7362000
Does anyone know what Led is used on the Yestech B2 light boards. I need to replace them and can not find a board, so I need to replace the LEDS. Or is it something else causing the leds to not go any brighter?
Electronics Forum | Fri Feb 24 02:33:29 EST 2012 | soppcb
Hi, guys, this is jack from soppcb technolgy in shenzhen, we are a professioanl manufacturer of PCB and PCBA, including single sided pcb, double boards, multilayer boards, HDI, aluminum led boards and so on, if any needs, pls contact me here or my ad
Electronics Forum | Thu Oct 13 15:38:18 EDT 2022 | proceng1
Do you have the ability to add copper thieving or otherwise balance the design? We had a customer making LED boards with a terible inbalance. Some of the boards would "smile" so badly in the oven that the leading edge touched the top. They switche
Electronics Forum | Wed Jul 11 16:40:27 EDT 2012 | georgeg
On the board, LTST-S320KGKT (LED) was supposed to be placed as shown in the figure. The pads and silkscreen with legend were also made as shown in the figure. But after the part was placed on the board, I realized that the sizes recommended by the LE
winsouce.jpg)
