Electronics Forum | Wed Jul 21 16:21:19 EDT 2004 | bobpan
Steve, We sent them back to the manufacturer and 'if' they are repairable they will repair them for a minimal cost...haha... and send them back to you. Have fun....
Electronics Forum | Fri Mar 19 07:18:14 EDT 2010 | grahamcooper22
Hi, do you know if your LEDs are moisture sensitive ? And if so what MSL level ? Surprisingly it seems that not all are, but some seem really sensitive. I imagine the differences are down to the plastics used and the LED manufacturing processes. I a
Electronics Forum | Thu Mar 18 18:07:21 EDT 2010 | grahamcooper22
Hi, First check what the Moisture Sensitivity Level of the LEDS is....you may need to ask the LED manufacturer. Once you've established it is moisture sensitive then follow latest version of IPC JEDEC 33 spec. for storage of them and drying them if t
Electronics Forum | Fri Mar 19 03:13:35 EDT 2010 | mun4o
Hi, First check what the Moisture Sensitivity > Level of the LEDS is....you may need to ask the > LED manufacturer. Once you've established it is > moisture sensitive then follow latest version of > IPC JEDEC 33 spec. for storage of them and dryi
Electronics Forum | Thu Feb 02 14:14:08 EST 2017 | siltron
Hi Muzzy, We are experiencing a similar issue with our Juki KE750, the machine did not perform zero rutine, some of the ALM4 led in the zeta ant theta drivers are turned on, and the SUB-CPU led "FAIL" is also on, did you mean that when your machine
Electronics Forum | Sat Aug 19 22:54:12 EDT 2023 | sonavc
Hi The machine run fine. Now I had the problem ZL or ZR driver Alarm. Turn on machine, everything is checked O.K I can be able to home the machine. When just start auto, the assembly or semi -auto. The machine is stopped, and show driver alarm ZL or
Electronics Forum | Mon Sep 26 18:46:37 EDT 2005 | stano
Hello. We have problem with MPA-V. Problem is with V1, V2 axis. Error is V1 AXIS MOVEMENT IMPOSSIBLE and V2 AXIS MOVEMENT IMPOSSIBLE. On the driver for this axis lighting error LED ST (sensor touble). It is problem in connection between motor encoder
Electronics Forum | Sun Dec 04 10:40:23 EST 2011 | bobpan
Do you have the motor power turned on? It is next to the main power breaker (front panel of machine). Are all the covers down? Are the side covers pushed all the way in? What is the led status of your driver cards? They should be all green with no re
Electronics Forum | Thu Aug 29 05:01:38 EDT 2013 | bobpan
Motor Error 5 is usually an interlock error. Take off the rear right cover and look at the red and green led's on the driver cards. If they are both lit....you have a door open or if you have carts....a feeder base switch is up. Good Luck
Electronics Forum | Thu Aug 29 14:20:17 EDT 2013 | nophsem
Thanks for the response bobpan! LED's on the driver cards work well (green with doors closed and both red&green on with door open), and I don't use the carts. The head doesn't move after power on and inmediately you can listen alarm.
