Electronics Forum | Wed Oct 13 08:37:49 EDT 2010 | denisp
we have a static problem with 0603 led when removing the plastic retainer from the tape and reel. same problem with the feeder causing reject and bad placement. is there someone having the same problem? and how to fix it. thank you
Electronics Forum | Fri Feb 01 07:21:32 EST 2019 | dfl
One of my 8mm feeders is blinking the red led after the pick-up. With both buttons the motor works as expected (forward/backward), but after the nozzle pick-up the motor moves forward and then the red led blinks. pressing the buttons the green led l
Electronics Forum | Sun Feb 03 07:36:17 EST 2019 | dfl
Hey Steve, I wrote to Bob, but he doesn't reply yet. Digging around, I found these: HANDLING COMPONENT VARIETY The adjustable Pocket Index function enables handling a variety of component tape reels or special component packaging. The following ins
Electronics Forum | Sun Feb 03 07:39:27 EST 2019 | dfl
POCKET POSITION PROGRAMMING This procedure ensures the components are properly centered at the tape feeder pickup point (over spring stabilizer). NOTE: The feeder can be reset at any time by removing it from the feeder base and reinserting it. This
Electronics Forum | Mon Jan 21 07:01:02 EST 2013 | ericrr
I can not believe this, We get back from Summer holidays turn on the first machine Juki KE750L goes to do a home and before the head moves, Error notice: rear feeder rise error, I go around the back, nothing out of place. but notice the receiver end
Electronics Forum | Sun Feb 03 08:46:34 EST 2019 | dfl
SOLVED The LED/phototransistor was a little of the center on the "index wheel" (don't know a better name, its the gear that pulls the component strip). The wheel works with a LED from one side and a phototransistor from the other, through a hole on
Electronics Forum | Fri Nov 06 20:43:58 EST 2020 | jmelson
Does anyone have schematics for the PC board inside a Quad IQ feeder? I have one that worked a few days ago, but now gives me blinking lights and doesn't move. Or, do you know what to do when it won't move? I have checked the contacts and the feeder
Electronics Forum | Thu Apr 18 17:42:26 EDT 2013 | navworx
Just because a feeder has 8 pins on the front > does NOT mean it is IQ. The IQ feeders started at > a certain level of feeder part number.....which i > do not remember being that many people dont use > the IQ system. > > Good Luck It has PLD v
Electronics Forum | Mon Apr 18 19:58:22 EDT 2022 | cbeneat
I had the same question. We have custom nozzles made by Count on Tools. I believe we found urethane works the best for the silicon domed LEDs. Have you slowed the feed rate down on the feeder? Also adjust the top tape to the back slot on the feeder.
Electronics Forum | Fri Jul 29 11:31:44 EDT 2022 | jojoled
Hi Guys, I have Juki PnP machine with 2 heads, and for some reason, whatever I do, I can not make the machine to use 2independent feeders for parallel picking up single component reference by both heads from 2 feeders. Example , imagine you have a
winsouce.jpg)
