Electronics Forum | Fri Mar 19 13:18:03 EDT 2010 | deanm
Regarding your question about buying equipment to vacuum seal the MBBs, according to the IPC/JEDEC standard, "Full air evacuation is not needed or recommended; light air evacuation will reduce the packaging bulk and enhance carton packing. Excessive
Electronics Forum | Fri Aug 02 11:45:26 EDT 2013 | garyck
Need to pick between an inexpensive Manncorp manual axial lead former or the Manix unit. Any one have any experience with either of these two units?
Electronics Forum | Mon Aug 05 22:10:38 EDT 2013 | jaimebc
We have HRFT-301U ( staple bend) is fairly easy to set up. All you need is t-handle Allen that I believe is provided with the machine. All adjustments to form a part, both pitch and lead length are mechanically adjusted by sliding the forming and c
Electronics Forum | Thu Dec 14 15:05:17 EST 2017 | emeto
I am pretty sure, you are looking into the wrong spot. Your paste is too much, or your part has very inconsistent narrow leads(that includes wrong pad design as well.)
Electronics Forum | Wed Nov 12 14:46:58 EST 2008 | hutch770
Greetings all, I'm pretty new to the SMT world, having been a class 10 fab monkey in my previous life. What I'm looking for is recommendations for pneumatic lead cutters. I need them to flush-cut as close as possible to the via without destroying
Electronics Forum | Wed Nov 12 16:04:11 EST 2008 | charliedci
I have about 8 pair of the 590 in use in thru hole production. Had to replace 1 set of blades because of overpressure (50psimax) and a valve over past year. They work well for light to medium work. The replacement blades were around $20.00.
Electronics Forum | Tue Feb 19 14:52:04 EST 2008 | dphilbrick
You also need to understand when using something like a Q Cutter you should resolder the board after you cut! Your alternative is to get someting that when you put your part in it cuts and clinces the part. Contact Systems makes machines that present
Electronics Forum | Mon Jul 08 18:45:53 EDT 2019 | assuredtech
Would you happen to have the Jig used to check that the component itself is in spec with UIC's general specifications? 1.) Component in spec. 2.) Correct 2.5mm pusher on the feeder / dispense head. Also set the conditioner guide where the comp enter
Electronics Forum | Tue Jul 09 14:02:01 EDT 2019 | daniel_marquette
Unfortunately, I don't get the Jig but the component is always the same LED. I measured a sample of those and they are consistent from the tape and after the leads being cut. About 1-2% of the component from the tape are already bent so I'm still foc
Electronics Forum | Fri Dec 10 12:40:44 EST 1999 | Brian W.
It sounds like the process is very labor intensive, and all the verification is done after the parts are soldered. Assuming you are hand placing the components: 1 - Contact Systems semi-automatic placement machine. It show polarity when placing, so
