Electronics Forum | Mon Aug 20 07:17:36 EDT 2012 | ericrr
Hi we have Juki KE-750L's is there any program to work out how many parts left on the reel, on the machine, the placement program does have a option to keep this number, but once you finish the run and start a new run the figure is lost. Unless I mis
Electronics Forum | Mon Aug 20 14:39:42 EDT 2012 | davef
Investigate these links * http://www.ehow.com/how_12128475_determine-number-parts-partial-reel.html * http://ox3.com/pprX.php
Electronics Forum | Tue Sep 18 10:52:14 EDT 2012 | sarason
Sounds like a plan. The usual way is to count how many you use on the job either by pre-calculation. Or how many clicks the machine counts and save the data before switch off, then drop it back into a spread sheet. This depends very much on the mach
Electronics Forum | Wed Aug 22 07:24:34 EDT 2012 | ericrr
how about this for resistor & capactors with 4mm pitch, all measurements in millimeters. cell A1 "Input inside diameter" answer in cell B1 cell A2 "Input outside diameter"answer in cell B2 cell A3 "Input layer width,(from inner to outside layer) (no
Electronics Forum | Sun Jul 14 16:46:38 EDT 2019 | rob1
I'm working on A DEK 265 Horizon and I need to convert it to right to left. I have changed the conveyor direction in software, however, the board stop position appears to be from 0 to 255 and I need it stop on the left hand side of the centre referen
Electronics Forum | Tue Jul 16 16:15:14 EDT 2019 | dekhead
If a few extra seconds of cycle time won't hurt you, recommend putting at max (3.0 sec) it will cycle all the way over to the Board @ Left sensor before extending BS and reversing. Otherwise play with the timing and requirement may vary from product
Electronics Forum | Tue Jul 16 15:58:53 EDT 2019 | rob1
I have entered a value for the "Right Feed Delay" and it resolved the issue. Thank you.
Electronics Forum | Mon Jul 15 09:03:44 EDT 2019 | dekhead
It uses the same BS position regardless of feed direction. In right feed, it passes Board under the camera and when (board @ stop) sensor detects board has passed, drops the BS and reverses conveyor direction. There is "Right Feed Delay" parameter to
Electronics Forum | Thu Aug 04 09:40:12 EDT 2022 | jojoled
Hi, did anybody face such error(attached)? After calibrate all axis I get this error. "E202074 : Z axis of left head : SERVO alarm. Turn off the power to the machine and perform inspection" - see attachement. Machine was fully working day
Electronics Forum | Fri Apr 21 23:13:59 EDT 2006 | valuems
The snema connecters are located behind the front cover, and to the left of the small power supply. The connecters are up side down. The front one is the left side and the second one back id the right side. Left is normaly the upstream and the rig
