Electronics Forum | Wed Dec 23 00:06:15 EST 2020 | ttheis
I believe I found the power supply you refer to on the back side of the pdp mounting panel. I will have a look at it.
Electronics Forum | Wed Dec 14 13:44:14 EST 2022 | assuredtech
Do you have the electrical schematic? The matting connector should be right there at the machine frame just under the mounting hole for the light tower. Light Towers can be an "option" on machine configurations, perhaps your machine was not configure
Electronics Forum | Wed Aug 03 20:28:10 EDT 2022 | cbeneat
We have been known to bring the break air to, and past .1 on the gauge. You have to be careful, as you increase the break air It can blow small parts that are close to any light, or send a part that it is trying to mount. So we always increase increm
Electronics Forum | Fri Jul 28 11:16:09 EDT 2017 | robertwillis
Yes it happens with any inline cleaner with small or light boards the pressure can cause them to flip. If they lodge in the links they can also cause damage to the conveyor. For small boards, flexibles etc you do need a mesh fixture of some sort or l
Electronics Forum | Mon Jun 26 10:58:16 EDT 2006 | J.E.M.
Question for anyone using panasonic super thin surface mount light touch switches EVQ-PLDA15. The above part has a recommended land pattern with two gnd pads.There is a little tab on each side of the part that i assume is suspose to make contact wit
Electronics Forum | Fri Dec 16 15:23:04 EST 2005 | Csabee
I think the Samsung SM320 is quite good machine..But I suggest that must assembly feeder cover to the feeder trolleys, because without that the tape feeders are not safe for the heads. Feeders should broke the head. chip components wrong light sett
Electronics Forum | Wed Oct 02 13:54:39 EDT 2019 | fundomikey
Hello, I have a problem with settings vision for LED (similar to this one: https://www.lumex.com/news/SML-LXIL0603-narrow-beam.html) on JUKI KE3020. The LED is mounted on the side. At the beginning I would like to say that laser recognition is impos
Electronics Forum | Fri Nov 05 10:59:30 EDT 2010 | methos1979
I have had my system for three weeks now. It is an MV3L. It is running version 4.5.0 build 2.1.2 software and it is very stable. I have not had a single crash. We are not a board manufacturer but rather use our system to inspect both populated an
Electronics Forum | Sun Feb 10 20:27:50 EST 2008 | jmelson
As long as it doesn't have a thermal pad soldered under the package, it shouldn't be a big problem. Small, pointed iron, stereo zoom microscope if you can find one, or a head-mounted magnifier. Lots of light. Rest the heel of your hand on the boar
Electronics Forum | Fri Nov 05 18:47:31 EDT 2010 | eadthem
I'm guessing when you say bare board you mean wet paste only? When you say the pads move slightly are your boards warped at all at the Vscore? What we do is use per modual fids. first you delete or don't make panel fids and then theres a option wh
The SMTA membership is a network of professionals who build skills, share practical experience and develop solutions in electronic assembly technologies and related business operations.
Training Provider / Events Organizer / Association / Non-Profit
6600 City W Pkwy
Eden Prairie, MN USA
Phone: 952-920-7682
