Electronics Forum: lighting head (Page 1 of 13)

io head unit kv8-m4570

Electronics Forum | Mon Sep 20 00:51:03 EDT 2010 | jeffr

This particular Yamaha Head I/O Board is a common failure. Yamaha supply an updated version which is less likely to fail. The cause of the problem that you see is due to the connectors on the flexing and damaging the inner layers of the board. The on

IP3 head 1 not placing parts

Electronics Forum | Mon Nov 10 23:20:55 EST 2008 | stanyserrao

Light Units are replaced with new if the problem > of lights then it will not vision process the > nozzle center measrement and resolution Jigs > too.. > > Jig is meauring in trace mode and > identifiying all leads which are fine > fitch. > >

IP3 head 1 not placing parts

Electronics Forum | Thu Oct 23 00:43:30 EDT 2008 | stanyserrao

Light Units are replaced with new if the problem of lights then it will not vision process the nozzle center measrement and resolution Jigs too.. Jig is meauring in trace mode and identifiying all leads which are fine fitch. But a 1206 resistor is

IP3 head 1 not placing parts

Electronics Forum | Wed Oct 22 13:39:38 EDT 2008 | evtimov

Did you check the lights? may be some leds burned there. Emil

GSM2 spindles Not seen for head

Electronics Forum | Fri Sep 25 20:11:58 EDT 2015 | ercdave1

Thank you for taking the time to read this post. I hope I can get some help since I am at the point where I don't know what to do. I have a Q block Universal GSM2 having some issues. I am getting an error message that reads. "spindles Not seen for

GSM2 spindles Not seen for head

Electronics Forum | Tue Sep 29 09:39:02 EDT 2015 | rgduval

Hey, David, For service, check out 4TechUSA over in Detroit. It's not Chicago, but, you're closer to Detroit up there than I am down here in Houston :) For your issue....do you have access to the UIC Knowledge Base? The first issue I found in the

Samsung SM320 VS Assembleon 8 head Opal XII

Electronics Forum | Fri Dec 16 15:23:04 EST 2005 | Csabee

I think the Samsung SM320 is quite good machine..But I suggest that must assembly feeder cover to the feeder trolleys, because without that the tape feeders are not safe for the heads. Feeders should broke the head. chip components wrong light sett

Samsung SM320 VS Assembleon 8 head Opal XII

Electronics Forum | Sat Dec 17 15:46:28 EST 2005 | Csabee

Samsung SM320 don't have sensor for recognizing component. Only using Fly&Fix camera. In first time the korean samsung service engineer advised me (3,7light settings for chips and the machine generated many dumps, sometimes 50 or more per day. But n

help GSM2 Spindles error: All spindles safe sensor not seen for head

Electronics Forum | Thu Mar 20 17:26:14 EDT 2014 | dave222

I tried to check for the emitter and the receiver and I notice that the receiver is screwed into the side of the head and not easily accessible so I decide not to mess with it. this is what I did. I activated all of the clutches for the spindles an

Royonics Bulbs

Electronics Forum | Mon Jul 26 10:00:21 EDT 2004 | jdumont

Does anyone have or know where to find the light bulbs that go into the light head in the old Royonics 510 through hole placement machines?

  1 2 3 4 5 6 7 8 9 10 Next

lighting head searches for Companies, Equipment, Machines, Suppliers & Information