Electronics Forum | Fri Jul 07 17:17:43 EDT 2023 | ttheis
We swapped the Y1 and Y2 pc800 controllers with no change. We swapped out the UIMC III-I cards from another machine with no change. VRM amps all look OK, no errors. The machine moves the head both in the x and y directions during the zeroing attemp
Electronics Forum | Mon Mar 18 11:04:39 EST 2002 | slthomas
At a previous employer we used a pneumatic dental type drill with nice results. The 1/4" hose is much more flexible than a flex drive cable, there's no motor module on the work surface, and the foot pedal for the air a little more elegant than two-h
Electronics Forum | Thu Mar 24 23:34:55 EDT 2022 | glasscake
My Koh Young 3030VAL errors on the homing routine. The "DTool" "MCS" gives me an error "Before homing, X-AAxis already checked negative limit..." "Before Hoking, Y Axis already checked negative limit..." "Please turn off the control-power-switch, an
Electronics Forum | Sat Dec 01 18:08:03 EST 2007 | jmelson
Hello, I just ran into a crazy problem with my CSM84. I did a batch of one side of a board, then loaded the program to do the top side, and it stops with the head over the 3rd component's feeder, and reports error 117:overflow. The maintenance manua
Electronics Forum | Fri Jul 07 17:33:25 EDT 2023 | jdengler
Since you haven't received any useful advise I will throw my 2 cents in. I do not know this machine but in general what you describe is an axis that does not get it's home pulse in time. Many machines will have an in-range sensor that gets flagged
Electronics Forum | Fri Dec 26 23:05:29 EST 2003 | tommy
It can be wrong pressure sensor switch setting,malfunction or low incoming air pressure.If incoming air pressure below the setting limit then 1 block stop message will display on screen.
Electronics Forum | Mon Oct 17 13:02:28 EDT 2016 | tdemon69
i have a MPM2000 now giving me 0 - hardware limit warnings..let me start off by saying that is was giving me x axis limit problems, so i replaced the x card with diff card. set all the switch and jumpers to x card , then i got 0- hardware . so then
Electronics Forum | Thu Oct 16 00:08:31 EDT 2003 | Dean
Why would you have troubles if and when you switch? Isn't that the point of materials evaluation? Understanding the impact and material capability BEFORE "betting the farm on it". I would never stake my career on a solder paste without an Engineer
Electronics Forum | Tue Apr 25 01:23:28 EDT 2006 | kanna
Thanks. currently we already reduce the temperature and change the bimetallic switch. can anyone help me on the alert problem. the alert trigger when the zone 1 section empty without board. current temperature setting is 187 even i lower the tem or i
Electronics Forum | Thu Oct 20 11:39:43 EDT 2011 | swag
Make sure the housing for the switch can move up and down freely (no lose parts/screws and the lead screw is clean and lubed with some light oil). I've had a tactile housing come loose from the lead screw = limit errors - it should be tight with no
.png)
