Electronics Forum | Tue Aug 04 10:19:38 EDT 2009 | swag
Here's a few ideas: If it has one, make sure the flexible coupler set screws are tight. Replace the tactile switch (often these appear to work fine in I/O but do not work properly in production). Clean and oil the tactile plunger if it has one. M
Electronics Forum | Tue Aug 04 13:44:05 EDT 2009 | swag
Check your DIP switch settings on new driver. Not sure about calibration. Try QMPM for password.
Electronics Forum | Tue Oct 14 10:52:35 EDT 2014 | swag
Can't help you with the manual but do have some tips: If it was shipped, it's possible someone tied axis or blocked stuff for shipping. Look for that. Look for bent sensor flags + go into I/O and check to see all sensors you can find are working.
Electronics Forum | Sat Oct 18 22:41:54 EDT 2014 | pfifla1
Can't help you with the manual but do have some > tips: If it was shipped, it's possible someone > tied axis or blocked stuff for shipping. Look > for that. Look for bent sensor flags + go into > I/O and check to see all sensors you can find a
Electronics Forum | Fri Feb 19 11:13:02 EST 2016 | ttheis
I'm setting up a product for the first time on my GSM after I completed debugging some other issues. The previous owners had the PWC axis disabled and the axis motor disconnected, so I re-connected it and enabled it and now it homes and moves. When I
Electronics Forum | Fri Feb 19 15:23:31 EST 2016 | ttheis
RESOLVED I adjusted the "Minimum Board Width" in the Board Handling Configuration to resolve this issue. I set the lane width to a larger value which did not hit the front limit and measured the difference between the actual lane width and the set l
Electronics Forum | Tue Oct 01 18:44:24 EDT 2013 | richardconnell
Hi, I have limited capability on the Z axis. The axis will home to the mechanical switch limit and then drop to a point which I asssume to be the fiorst zero point below the mechanical switch limit. Then it gives the error. There is power to the mo
Electronics Forum | calum23 |
Fri Feb 12 02:55:13 EST 2021
Electronics Forum | Fri Apr 28 16:03:31 EDT 2017 | ilavu
I have GSM1 (OS/2) machine and it does not zero. The Y axis comes to all the way front to hard stop. I replaced the limit switch before the hard stop and can not find any way to test the signal from limit switch in diagnostic. I like to replace the c
Electronics Forum | Thu May 04 15:32:21 EDT 2017 | dilogic
On the HP Servo panel there are LED's that indicate state of limit switches - so you can see if the problem is in the switch or somewhere else. Did you check it?
