Electronics Forum | Fri Jun 17 10:59:22 EDT 2011 | beta
yes there is - I think it is called front print limit & rear print limit
Electronics Forum | Sun May 20 01:37:58 EDT 2012 | vileo72
Hi , Thanks for the link and could understand the limit setting . Regards Vikas
Electronics Forum | Tue Oct 01 18:44:24 EDT 2013 | richardconnell
Hi, I have limited capability on the Z axis. The axis will home to the mechanical switch limit and then drop to a point which I asssume to be the fiorst zero point below the mechanical switch limit. Then it gives the error. There is power to the mo
Electronics Forum | Wed Jun 29 15:42:19 EDT 2011 | dekhead
Yes it is "Print Front Limit" and "Print Rear Limit". Negative value extends the stroke, Depends on software version how useful it will be, as there are differing limits on how much you can extend the stroke. http://www.dekhead.com
Electronics Forum | Sat Apr 21 04:39:45 EDT 2012 | brotakul
I am using different equipements for SPI such as Koh Young and Cyber Optics machines. I am looking for implementing a general procedure (SWP) for setting LSL's and USL's on the products on which the customer does not specify any limits on the solder
Electronics Forum | Fri Apr 28 16:03:31 EDT 2017 | ilavu
I have GSM1 (OS/2) machine and it does not zero. The Y axis comes to all the way front to hard stop. I replaced the limit switch before the hard stop and can not find any way to test the signal from limit switch in diagnostic. I like to replace the c
Electronics Forum | Thu Mar 17 09:56:34 EST 2005 | jmedernach
Tx, Your spec limit is the point at which you expect to see a failure. In other words, what is the probability that you'll see a short when you have .008" of solder paste? What is the probability that you'll see an open if you have .004" of solder
Electronics Forum | Fri Apr 12 15:48:33 EDT 2002 | jersbo
SPC for each assembly(I use C(for board defects)NP(for unit defects) at the end of reflow to determine process capabilities determine Control limits. Once control limits are set, inspectors stop the process until out of control limit is addressed and
Electronics Forum | Wed Jun 11 10:24:23 EDT 2003 | kris
Hi, The percentage of lead (0.1% or otherwise) is still being debated in the EU where the legislation is in place. The industry is pushing for a 0.2% limit,(if lead-free has to be) as it is considered a limit where solder can be recycled economical
Electronics Forum | Fri Feb 24 13:48:33 EST 2006 | chris
Does any body know how to change the inner width limit on a P-98 BTU oven? The inner limit is 6 inches, but I need it to be about 1.5 inches. Do you have to have a factory service disk from BTU to gain access to the limit. If so, does anyone have
