Electronics Forum | Thu Feb 10 14:56:50 EST 2005 | jimdugan
The Mydata machine is a very good high mix low volume machine. If you buy from Mydata you will be better supported, than if you buy from a broker. I would recommend you buy the newer My series machine. The TP machine was a good machine but the My ma
Electronics Forum | Sat Jan 29 04:59:02 EST 2005 | Grant
Hi, MYDATA's are ok for lower volume, and they are very flexible. If you only have 1 or 2 trays of components and are on a tight budget, then you can even place the trays on the Y wagon behind the PCB so you can get away without the tray wagon. Al
Electronics Forum | Wed Feb 19 09:52:45 EST 2014 | brendansales
Dear Rob, Got to the maintenance menu, under the Motor section, I selected Z motor and tried to initiate motor, there was no movement on the machine and I had the error message as below: F-MOT-MSETDYN Z/12: Position counter dead I suspect that ser
Electronics Forum | Thu Feb 10 14:27:07 EST 2005 | cyber_wolf
First of all, whom are you getting it from ? Mydata, or a used equipment broker. If you can tell me what machine type you are looking at, then I can tell you what to look for. (MY-series, or TP series) Most important things right off the bat: *Machi
Electronics Forum | Wed Apr 07 21:49:44 EDT 2004 | Ken
My favorite kind of calibration is where the machine learns what it did incorrectly. Then fixes itself! However, there are many types of machines that rely on human feedback as to the results of what it did. nozzle calibrations involve many factors
Electronics Forum | Tue Dec 21 12:28:11 EST 2021 | vtdivtecs
hey all, I had a comically bad failure yesterday while working with my pick and place, a part got dropped at exactly the wrong moment and flung a bracket up into the tool path, severely damaging the hydra controlboard that is next to the x camera. T
Electronics Forum | Tue Sep 29 13:59:08 EDT 2009 | cyber_wolf
The Hydra camera is a linescan camera on our machine.
Electronics Forum | Thu Aug 30 20:58:50 EDT 2007 | ronsou
Hello all Has anyone ever upgraded their machine from the Hydra camera to the linescan camera? I was wondering what your cost was. I recently requested a quote and almost fell out of my chair when I recieved it. Thank Ron
Electronics Forum | Sat Sep 26 21:45:37 EDT 2009 | casmt
It didn't see the ref points on the bottom of the hydra head. start by checking the camera for dirt or dropped parts. Is it a hydra camera or Linescan?
Electronics Forum | Thu Jan 05 12:33:30 EST 2017 | rgduval
If you haven't resolved this yet, I think you're going to want to go to either the part or the package (I'm not sure which one off hand), and make sure that the hydra heads/tools are selected for placement. You'll also want the vision set to the lin
