Electronics Forum | Mon Oct 10 07:40:33 EDT 2005 | pjc
To make an "L" you use a 90 deg turn unit, a.k.a. "diverter" conveyor, then connect to a straight or linking conveyor. Go to this link to see turn unit: http://www.flexlink.com/wps/public/s/10000/c/29667
Electronics Forum | Mon Mar 20 08:36:30 EST 2006 | jdengler
I've never had this problem on an Omniflo oven, but have seen it on others. It has always turned out to be mechanical. A bearing going bad or FOD in the rails. I would pull the chains and carefully check each link of both chains, all of the bearin
Electronics Forum | Mon Oct 10 11:32:04 EDT 2005 | davef
Conveyor equipment suppliers are: * FlexLink Systems, Inc.; 6580 Snowdrift Rd; Allentown PA 18106; 610 973-8230 F 610-973-8345 http://www.flexlink.com * JOT Automation Inc.; 1201 S. Beltline Rd.; Coppell TX 75019; 972 393-5564 Fax 972-745-9013 http:
Electronics Forum | Thu Mar 23 09:29:58 EST 2006 | Joe
I agree that it's the probably the chain. The links get dirty and can bind up over time. When you pull the chain, check to see that each link rotatates freely with its adjacent link. I bet you'll find one or more links that are binding. This is the s
Electronics Forum | Mon Mar 20 11:48:21 EST 2006 | Chunks
jdengler may be right. Had a 10 zone do the same thing. It was a couple links in the chain.
Electronics Forum | Mon Mar 27 11:03:06 EST 2006 | mapell
Tribol 1430 is the latest generation oil, 930 can't take lead free temps. Please see the following link.... http://www.castrol.com/castrol/productdetailmin.do?categoryId=82958955&contentId=6004371 If your getting alot smoke and residue, reduce the
Electronics Forum | Thu Jul 18 00:08:31 EDT 2019 | mk15
hank you for the tips. MOT boards have already changed. The sensor on the conveyor responds. In service mode, the WIDTH MOTOR - OK, HOLD MOTOR - OK, SET CONVEYOR - OK, only error TRANSPORT - F-MOT-MSETDYN conveyor transport / 1250: amplifier DC-link
Electronics Forum | Wed Jul 17 02:31:30 EDT 2019 | mk15
I am looking for some help for where to look to fix this MY15E problem.After hardware initiation appear F-MOT-MSETDYN conveyor transport/1250: amplifier DC-link too high.Any suggestions? Thanks
Electronics Forum | Wed Jul 17 17:56:38 EDT 2019 | rgduval
Check the MOT board. You can usually swap out the individual MOT boards, and see if the problem moves. If it does, you can isolate which board has gone bad. You can also check the encoder on the conveyor, to make sure that is still working correct
Electronics Forum | Wed Dec 17 14:27:57 EST 2003 | Pete C
FlexLink purchased PCT Automation Systems Corp. http://www.flexlink.com/
.gif)
