Electronics Forum | Mon Jul 24 15:50:51 EDT 2023 | proceng1
I am going to be using a pressurized dispenser for Chemtronics CM1 peelable mask. I need to find a solvent that will work for flushing the system. I tried Xylene that we have here and it does ok, but not as good as I'd hoped. It works very well fo
Electronics Forum | Tue May 19 11:56:59 EDT 2020 | philc
Do you buy in the PCB's from a manufacturer? If so, they may well offer such a service for you. We get quite a few different boards that come with either Kapton tape, or liquid masking already applied.
Electronics Forum | Mon Jan 26 11:41:04 EST 2004 | pbarton
Some questions: Is the peelable/spot masking only being applied to the earthing points on the one side or to both sides? Is the peelable mask you are using specifically designed for coating masking or is it the same as that you use for masking sold
Electronics Forum | Tue Jan 27 10:54:45 EST 2004 | patrickbruneel
I would suggest trying an acrylic peelable mask. In most cases peelable temporary masks are latex materials. Since you use an acrylic conformal coating it makes sense to use a mask with the same make up to avoid incompatabilities. Link to acrylic mas
Electronics Forum | Mon Jan 26 07:27:43 EST 2004 | loz
I have a product that has earthing/positioning holes, as they are to be used for earthing purposes they need to be free from conformal coating. This pcb is double sided. I have used spot/peelable mask to protect these holes. However when the conforma
Electronics Forum | Tue Jan 27 07:10:06 EST 2004 | Rob O
Try using Kapton Tape or masking tape dots instead of the liquid mask.
Electronics Forum | Tue Oct 31 19:34:30 EDT 2023 | dilogic
I have considered this solution, but syringe application is very slow and it's hard to control thickness. It's good for partial covering or applying peelable solder mask. We need to coat circular board ca. 10cm in diameter. Takes a while even with sp
Electronics Forum | Fri Feb 20 17:04:26 EST 2004 | Long
Hi I am looking for some type of peelable mask or plug to cover the connector during the conformal coating. The problem we have is the moisture get into system and eventually penetrate under the connector creating short circuit to the board. What I r
Electronics Forum | Fri Apr 21 17:46:29 EDT 2006 | SD
First of all, do not use kapton tape! It tends to cause a dewetting effect around the tape. A call to Humiseal will explain why. There's not really a blanket answer to your question.... Removing cured liquid mask can often result in a fillet ef
Electronics Forum | Wed Apr 19 16:43:05 EDT 2006 | samir
Silicone-based coatings "repel" most foreign,non-compatible materials like peelable solder mask, and rubber or vinyl boots. The result is, uncured material around the vicinity of where the boot was. Trust me. Been there and done that. As a rookie
winsouce.jpg)