Electronics Forum | Wed Jul 19 02:37:24 EDT 2017 | bukas
Hello everyone, i recently got Ersa ETS 330 wave machine '94. I got it running and heaters and flux pumps are ok, but I have problem with 2nd wave pump. It runs for 10-15 sec and then shuts down with error message on display. I checked bearings and
Electronics Forum | Mon Jan 20 11:11:24 EST 2014 | fnorradd
I have an Ersa Versaflow selective solder machine (single bath) which runs via a Profibus control system. I have checked all of the settings on the inverter, and all of the connections and outputs throughout the machine, but the machine returns a 68
Electronics Forum | Wed Jul 28 11:47:16 EDT 2004 | GCronin
I am looking for a consistent method of applying no clean liquid flux to solder pads. My main concern is if I use a standard air-over type dispenser mounted to an automated arm that the liquid flux will make a mess and not be consistent. I'm not to
Electronics Forum | Fri Nov 05 14:00:07 EST 1999 | John Thorup
You know, Rich - if the only problem with your present method of delivery is that the container runs dry and the pump sucks air you can add a non-invasive low level alarm quite simply and for about $100. A suitable adjustable sensitivity capacitive
Electronics Forum | Mon May 11 13:36:11 EDT 2009 | duso02
It really depends on what method you used to mask. Liquid mask, tape, rubber boots, etc. It is something most learned thru trial and error, much like running the parylene machine. It's never as easy as loading it up, turn it on and watch it go!
Electronics Forum | Wed Mar 17 10:12:16 EDT 2010 | dj_jago
Is it the pressurized system or the pump system you have fitted to the machine? Are you getting an error message 'No flow nozzle 1'? Check the 'ShoRate' gauge at the back of the machine and make sure the ball bearing rises in the glass tube when you
Electronics Forum | Sat Jul 23 09:19:17 EDT 2016 | dalpets
I want to place smd's by hand from tape strips using a vacuum pump. What is the orientation of polarised smd components on reels/tapes? Is there a standard manufacturing orientation, or are there variations? I understand some manufactures have part
Electronics Forum | Mon Apr 09 09:39:40 EDT 2018 | justconmac
Having an issue with tracking for the Vitronics Soltec Delta 3. Wave will not give error on "expected PCB at exit" but will still show 1+ pcb's in the wave when the machine is empty. This is causing solder pump to idle unnecessarily. Outfeed sensor i
Electronics Forum | Mon Jul 01 22:24:10 EDT 2002 | Por
Thanks for your advise Normally, We do not add any liquid flux (clean or No-clean) during touch up process but this case is an error. Lonco 23F is Nc flux. but our board is clean. However, there are 6 boards that found the white residue and our
Electronics Forum | Tue Apr 08 08:01:35 EDT 2014 | cyber_wolf
So we had a ringblow pump blow up in our CP642. We replaced it and now we are getting hardware NG errors very intermittently.(2-4 times during and 8 hour shift) I see that the x-motor fan, cam motor fan,and oil cooler are all in this circuit. When i