Electronics Forum | Tue Dec 05 20:55:35 EST 2017 | tristanl
Hi all, We traded our 4c work holder for a transport with another company. Eventing works, except that when I put a board in it does not index. All the other functionality seems ok. The rail width moves, I can eject the board, and it knows it needs
Electronics Forum | Mon Mar 20 09:08:42 EST 2006 | mapell
AR Sounds like dirty chains... couple ways to check... Pull off the drive chain for the conveyor. Place a wrench on the (unload end) drive shaft and spin, if it is a bit tough.. dirty rails. Also look at load end of chains. The chain goes low and w
Electronics Forum | Wed Sep 26 07:40:30 EDT 2012 | highmillr
I had this problem at another plant with the UP 2000....When the machine resets, The left and right side of the conveyor misaligns, causing the conveyor to be tight on the loading end and boards falling out of the unloading end. or vise versa...the t
Electronics Forum | Thu Aug 13 14:43:23 EDT 2015 | alphatronique
HI i try to figure how the "Manual load adapter" work on a T3 Table machine ? seem that the table always try to move the board to the the left sensor location ,but if i use the magnet manual table it will never find the board on the table convey
Electronics Forum | Mon May 03 18:47:50 EDT 2021 | ttheis
One of our gsm machines has recently started activating the upline conveyor while the machine is working causing boards to double load. Has anyone seen this before or have suggestions where to start before I dig into schematics? Thanks
Electronics Forum | Wed Jul 06 10:22:04 EDT 2005 | PWH
At times we have had this problem with our AP25 due to one of the conveyor belts slipping. Load a PCB and check to see that both conveyor belts are running at the same speed. If not, tighten the one that is dragging. Hope this helps.
Electronics Forum | Thu Jul 19 23:52:17 EDT 2001 | Victor
Load Factor = Board Length / (Board Length + Space) (you can get the maximum loading factor from the manufacturer, usually ranges from 0.5 to 0.9) Oven Throughput = (Conveyor Speed x Load Factor) / Length per Board
Electronics Forum | Sat Jun 26 21:17:34 EDT 1999 | Bob Huelsenbeck
Anyone having any conveyor rail shaking on Electrovert wavesolder machine model "Electra"? The conveyor shakes more with a pallet passing through the machine, particularly when the 20" pallet is passing from spray fluxer to the first pre-heater. Here
Electronics Forum | Sat Mar 25 06:07:41 EDT 2023 | smtusa
The part that sticks out in the rear for conveyors can that be removed if running in manual pcb loading only?
Electronics Forum | Tue Nov 14 21:55:54 EST 2000 | Dave F
There's a boat load of causes for icicles. Favorites are: * Conveyor speed too high * Conveyor angle too high * Contaminated solder
