Electronics Forum | Sat May 07 04:28:51 EDT 2005 | grayman
try checking the speed/conveyor driver,encoder,comunication I/O Board system and lastly the program. If the driver is at fault replaced it do not repair it. If software try to load it again but make back up.
Electronics Forum | Fri Jun 21 03:33:54 EDT 2019 | romford_navy
It’s now working correctly Had to re-load MMI software to get new System Files
Electronics Forum | Fri Aug 17 09:42:18 EDT 2001 | Hussman
G'Day All, I have a couple of new Panasonic MSR's. Whenever I load a new program into the machine, I have to manually feed the first PCB onto the X/Y table to get it to run. After that, they run just fine. Panasonic is going to be in and they hav
Electronics Forum | Tue May 06 12:49:50 EDT 2008 | markhoch
Ya know a little clear RTV around the feet of your conveyors will keep them from moving when Bubba the Quality Director needs to take a load off and leans against it. And if you ever need to move them later, just cut around the base with a box cutter
Electronics Forum | Mon Jul 20 23:06:49 EDT 2009 | mika
10 or even up from a UIC conveyor of the old model - probably SMPI is the connector from UIC fully loaded, then full SMPI, but not all of them are used. Just Good board, bad Board, send, receive acknowledge. It is possible to convert this into SMEMA.
Electronics Forum | Wed Oct 15 09:49:16 EDT 2008 | slthomas
So, are you putting the loaded carriers into a batch oven, or unloading the carriers onto an inline oven conveyor, or something else? Also, have you talked to your paste supplier to see what they might suggest? They might have a paste with an extend
Electronics Forum | Tue Mar 19 16:55:54 EST 2002 | Steve E ( Fujiamerica )
This problem happens when a dark part is placed where the main conveyer stop sensor is located.The machine does a board check ( back to loading pos ) . If a part is under the sensor it absorbs the beam and the machine thinks there�s no board. The ta
Electronics Forum | Wed Jul 24 06:20:11 EDT 2013 | JB
Hello, we have just bought a used nutek ntm110l and are looking for an instruction manual, anyone know where I can download one? Issue we have is that the bottom conveyor is constantly running, is there anyway to stop it? until we load a rack? some j
Electronics Forum | Sun Jan 17 10:27:01 EST 2021 | ecogroup
Thanks for replying Bukas...few days prior we found out it was the conveyor IF board. Changed it, all the contactors now engage. But now have these errors: Opened [SYSTEM] file is created by #1 machine. No command resonse from handler. (0x1000)
Electronics Forum | Thu May 27 16:23:12 EDT 2004 | davef
Process Trials Procedures. Standard trials are often conducted on reflow ovens by production engineers during product assessment, machine approval or in process set-up. The following trials are also used by machine suppliers during equipment develop