Electronics Forum | Mon Apr 09 10:16:14 EDT 2007 | davef
Pick and place: * Fuji: The largest pcb size is 20" by 18" for pick and place; 18"x14" for chip shooters. Fuji NP XL series allows 27 by 23 inch boards using a conveyor. * MYDATA has machines that can be configured to 34" X 44" X 0.500" * HSP 4796A a
Electronics Forum | Thu Mar 06 12:37:05 EST 2008 | realchunks
Long, yellow, ugly toe nails will have the same affect on your boards.
Electronics Forum | Wed Mar 15 04:32:14 EST 2006 | rlackey
Hi Brad, I don't know if this helps, but we had a policy of not accepting x-outs on rigids, and of max 10% per panel on Flexy boards (as long as the local fiducial was blacked out for the bad board) I'm always suspicious of x-outs as it points to pr
Electronics Forum | Thu Apr 20 14:33:18 EDT 2006 | dirk29
We had that problem with our printers we just drill and tap the top end of the stop and put a short screw in to allow us to adjust the top height of the stop and catch the board. Be careful not to make it to long or to could restrict the board from l
Electronics Forum | Thu Feb 03 08:20:49 EST 2000 | JAX
Once you have the capabilities to track a board from the initial stages in kitting all the way out the door in box build the possibilities are endless. You will now have: 1. An exact count of your companies WIP. 2. The exact location of every board i
Electronics Forum | Wed Jul 04 13:25:03 EDT 2012 | davef
Baking boards to remove moisture takes a lot more energy than you'd think. Following on with this, Chris Hunt from NPL gave a presentation at IPC APEX 2012 about the results of his research ["Impedance Testing for Sensitivity to Delamination in Print
Electronics Forum | Tue Jul 19 12:03:34 EDT 2005 | cyber_wolf
CLampron, There is no place for PCB thickness in a Mydata program. The board thickness is of no consequence.(As long as the thickness is uniform across the entire board) When you run a program, the Z axis touches the surface of the board to determin
Electronics Forum | Mon Oct 30 03:18:09 EST 2006 | geb
Hi Mika, Thanks for your reply. We've managed to narrow down the fault to the control board (long rectangle one in front of the camera). It turned out to be a logic IC that had blown MM74HCT244N (U17 I think). A circuit diagram would be useful beca
Electronics Forum | Wed Jun 02 15:29:47 EDT 2004 | pr
Make sure the board is stopping at the center of the worknest or you will waste lots of time (you'll get software limit errors when you try to find fids.). If it's not in the center, you need to go in and reteach from scratch (doesn't take too long).
Electronics Forum | Thu Sep 14 09:29:08 EDT 2006 | Steve Pollo0ck
James, is the board 24" long or print area. Essemtec offers a printer the SP900 with a 23.93" x 21.25" print area. http://www.essemtec.com/e/147.php here is the link to our website with a video. It is sold and supported in the US by Essemtec USA. it
winsouce.jpg)