Electronics Forum | Fri Feb 11 16:11:52 EST 2005 | Grant
Hi, Your right, and that's the thing I liked about MYDATA, even though we are selling ours now, and putting in Fuji'. I would still by a MYDATA if I was starting again, and doing low volume. When we started we kept our first product as simple as po
Electronics Forum | Wed Mar 01 16:52:43 EST 2000 | Dave F
Hey Hany: Here yago: On power outages: Talk about fun!!!! Can we have more of �em?? � You�re correct that a UPS to run your reflow is very expensive, but all you have to run is the belt motor. That�s "cheap!!!!" Get UPS sizing information from
Electronics Forum | Thu Feb 17 21:45:26 EST 2000 | Dave F
Steve: Wadja mean "I fixed it, now tell me what I did to fix it." Steve, you�re one scary guy. ;-) "Steve�s Longer Pad Theory" - Stubby pads will not make solder flow-up the leads of a QFP100, leaving sparse solder on the pads. Given a choice, s
Electronics Forum | Thu Feb 17 14:10:37 EST 2000 | C.K.
I'd have to agree with JAX here. This forum is intended to be a "Technical Bulletin / Newsgroup" and nothing else. Truthfully, these posts of the "old-timers" announcing their departures is getting..well.....OLD. I hate to see the Old-timers leave
Electronics Forum | Thu Feb 10 22:31:11 EST 2000 | Dave F
CK: If you�ve done everything under the sun process-wise at the wave: different fluxes, more heat, less heat, more contact time, and less contact time; and are running out of ideas; let me table some thoughts. � "Don�t mess with Mother Nature."
Electronics Forum | Thu Jul 13 04:01:02 EDT 2000 | JohnW
Dave, Firstly..how the heck are you?..been a while.... Ok so I'm running an Electrovert Electra witha hot gas knife, & I've got large server boards going over the wave. I've seen us loose chip, mainly Tants on the hot gas knife...ain't good especia
Electronics Forum | Wed Mar 01 16:52:43 EST 2000 | Dave F
Hey Hany: Here yago: On power outages: Talk about fun!!!! Can we have more of �em?? � You�re correct that a UPS to run your reflow is very expensive, but all you have to run is the belt motor. That�s "cheap!!!!" Get UPS sizing information from
Electronics Forum | Thu Feb 17 21:45:26 EST 2000 | Dave F
Steve: Wadja mean "I fixed it, now tell me what I did to fix it." Steve, you�re one scary guy. ;-) "Steve�s Longer Pad Theory" - Stubby pads will not make solder flow-up the leads of a QFP100, leaving sparse solder on the pads. Given a choice, s
Electronics Forum | Thu Feb 17 14:10:37 EST 2000 | C.K.
I'd have to agree with JAX here. This forum is intended to be a "Technical Bulletin / Newsgroup" and nothing else. Truthfully, these posts of the "old-timers" announcing their departures is getting..well.....OLD. I hate to see the Old-timers leave
Electronics Forum | Wed Feb 07 21:56:00 EST 2001 | davef
Every critter out there with large incisors adapted for gnawing and nibbling has a different theory of solder ball formation. [My theory: It�s punishment for using NC fluxes. Stand and deliver. My solder balls end-up in the gross filter connected