Electronics Forum | Wed Sep 23 07:51:28 EDT 2015 | kkay
We have been experiencing an issue where our Panasonic film caps on a board are losing their rated capacitance. We are well within their recommended reflow specs and no other operation exposes the part to a temp of more than 160°C. The caps will read
Electronics Forum | Thu Sep 24 09:28:13 EDT 2015 | rgduval
No direct experience with this particular issue....but, I do know that measuring capacitance can be tricky. How are you arriving at this conclusion? Are you measuring the caps on the bench before assembly, and then on the boards post assembly? Cap
Electronics Forum | Mon Aug 23 16:28:14 EDT 2021 | rodrigo
Hi all, One of our Fuji IP3 (we have two) keeps losing the proper data (proper, status, programs) when off for a couple of days or so. I changed the battery on the MP board (its voltage looked fine: 3.6v) but that didn't fixed it. I notice a super ca
Electronics Forum | Tue Aug 24 19:32:16 EDT 2021 | jdengler
I would start there. Swap MP boards between the 2 machines to see if the problem follows. If that doesn't change anything then try the SCSI board, you can continue until the problem moves to id the bad board.
Electronics Forum | Wed Aug 25 21:41:12 EDT 2021 | same problem
I'm having same problem with one of my CP-642s. We checked cards and now the monitors are not turning on.
Electronics Forum | Mon May 24 03:21:33 EDT 2021 | sophyluo1985
Hi,I'm QUINN form GOLDLAND China,What you should say is Intelligent warehouse management system (MT-WMS) solution；
Electronics Forum | Mon May 24 22:54:34 EDT 2021 | SMTA-64387687
Take a look at Inovaxe.
Electronics Forum | Mon May 24 16:08:43 EDT 2021 | robl
Can you have the SMT lines or feeder carts as "stock locations" on your system and issue them to that location? then at least when you go to your pick list you'll know where it is. That's assuming you can do this quickly.
Electronics Forum | Mon May 24 17:01:22 EDT 2021 | emeto
The good solution is to adopt ERP system and barcode tracking for everything you have in inventory. If not, SMT supervisor will keep super complicated excel sheets to track what is where..... Or.. you can request all to be kitted together and confirm
Electronics Forum | Sun May 23 22:07:43 EDT 2021 | needsmthelp
Hello, I recently became the SMT supervisor where I work. I have experience in much of the other areas but haven't actually done SMT work myself. An ongoing issue that I'm having is parts/reels related. If the person responsible for kitting starts g
