Electronics Forum | Wed May 11 09:33:52 EDT 2005 | tforbes
Thanks everyone! You gave me a lot of things to look at and investigate further. Cheers!
Electronics Forum | Tue Sep 24 10:09:52 EDT 2013 | leigh
Windowpane your ground planes, this will prevent a lot of voiding.
Electronics Forum | Wed Aug 15 16:25:52 EDT 2018 | ceharperc1
Anyone with a lot of printing experience, especially in proflow process? I am seeing a lot of voids in the bottom of the head after running. Will run with multiple good assemblies with paste volume being between 60% and 150%, out of no where we wil
Electronics Forum | Thu Jul 26 13:31:52 EDT 2001 | Hussman
John, Are these spots the result of repair? I notice a lot of repair people love to squirt flux onto the board when they repair it.
Electronics Forum | Tue May 06 22:31:52 EDT 2003 | yukim
Yes, we did try: built a lot of 200 PCBs with Sn62Ag2 solder paste (we have been using Sn63) and it helped, but not eliminated the problem.
Electronics Forum | Fri Oct 29 09:06:52 EDT 2004 | Rob
Hi Paddy, There's been a lot of low cost second user underfill equipment around recently, I've seen stuff go for as low as �20K - but make sure a dispense head is included. Good luck, Rob.
Electronics Forum | Mon Jan 31 14:26:52 EST 2005 | lyrtech
Hi, I'm searching for an alternative to stick feeder and vibratory feeder for SOIC-8 on a FUJI IP-2. Does anyone has a suggestion? Thanks a lot!
Electronics Forum | Thu May 12 14:52:13 EDT 2005 | amejia
Hi Patrick, I checked out the link and I think that just might be crazy enough to work. I'll have to research it a little bit more, but I think this would be the answer. Thanks a lot to everyone for all your help and suggestions.
Electronics Forum | Fri Sep 02 08:52:36 EDT 2005 | davef
Dougs: What is the purpose of this test? Lately, we have had a lot of boards that do not withstand the Drive-Over The Board With A UPS Truck Test. We wonder is the is some relation between our test failures and your customer's.
Electronics Forum | Thu Mar 02 17:52:59 EST 2006 | slthomas
Is this a new customer or an old one? That's quite a lot to ask if you're not accustomed to performing those analyses.
