Electronics Forum | Wed Apr 28 10:29:04 EDT 2004 | dougt
By "placement pressure" I assume you mean force. I don't know of placement machines that have transducers mounted on the placement spindles that actually measure force. We made a board with a force sensor mounted through a hole so that it was the sa
Electronics Forum | Thu Apr 29 10:35:31 EDT 2004 | dougt
Start with a load cell (force sensor), you will need one that can handle the force range you will be placing. Someone please correct me on this if I'm wrong but I seem to recall that placement force runs in the range of a couple hundred grams. Chec
Electronics Forum | Mon Apr 16 15:28:10 EDT 2018 | emeto
If you have pressure sensors in there(most contemporary machines have), value is probably right. It doesn't mean though that the value is correct(see the upper post)
Electronics Forum | Fri Apr 27 09:41:44 EDT 2018 | cyber_wolf
Typically freezing and air conditioners equals a low charge.
Electronics Forum | Fri Apr 27 02:17:37 EDT 2018 | bukas
hello everyone, I have issue with one of my DEK air conditioners, it starts to freeze soon after we turn it on. most probable cause is low air flow or low refrigerant pressure. does anyone know what is operating refrigerant pressure range for DEK ai
Electronics Forum | Thu Apr 12 08:14:43 EDT 2018 | cyber_wolf
The way to determine correct pressure (in my experience) is to start out at what you would consider to be a low sq. pressure setting. You are looking for it to leave a slight film of paste on the stencil. Start increasing pressure in small incremen
Electronics Forum | Wed Apr 19 20:33:14 EDT 2006 | davef
I just flew in from (insert city) and boy are my arms tired. pr: Likely, you're correct. The "pound-inch" units should have been the give-away, for us. Good catch. If this is the case, the frame fabricator would be the best source for tensioning
Electronics Forum | Fri Sep 07 15:20:27 EDT 2001 | ksfacinelli
We have two batch systems installed from Aqueous Technologies and have been very please with there performance and reliability. One machine is utilizing a 5hp pump and generates 60psi the other is a 3hp version and is about 40psi. I think the most
Electronics Forum | Fri Sep 07 14:09:57 EDT 2001 | aqueous
Hi Carol, Pressure requirements have changed over the past few years. In the recent past, aqueous cleaning systems relied on high flow, low pressure �flooding� techniques. 20 � 30 PSI pumped through large orifice nozzles. With ever increasing boa
Electronics Forum | Fri May 30 12:41:39 EDT 2008 | severs
I say that there is a market... The question is this: -How big is the market? -Is it worth going after? -Are you the person who can do it? Cost is everything to some people. There will always be a certain segment of buyers who will buy a product base