Electronics Forum | Wed Jan 07 17:39:26 EST 2015 | duchoang
Additional info: I use SAC305 solder paste on Enig PCB.
Electronics Forum | Wed Jan 07 17:34:52 EST 2015 | duchoang
Customer puts our board to thermal test. Test cycle is -55c to 85c, repeat cycle in 15-20min. After 600 cycles, lot of TSOP joints are cracked, leads lifted. There are reasons such as thin PCB, mechanical impacts, warped PCB... My question is, how lo
Electronics Forum | Thu Jan 08 15:49:10 EST 2015 | emeto
I bet you that the problem comes from the ENIG brittle solder joints. About low temperatures I think you can go to the absolute 0 and the device should still work.
Electronics Forum | Tue Feb 14 01:00:47 EST 2017 | soldertraining
Soldering Bath - When we need to tin high-power contacts or a lot of wires, for example, in making harnesses, a regular soldering iron is either impossible to use due to the high thermal capacitance requirement, or takes way too long to perform the t
Electronics Forum | Fri Nov 05 21:41:46 EST 1999 | chartrain
Temperature vs time is what soldering is all about. The faster you run your conveyor, the more heat will have to come from the pot for a given assembly. Example: You heat the board to 200F top side through the preheaters. Eutectic 63/37 melts at 361.
Electronics Forum | Thu Sep 16 12:06:29 EDT 1999 | Scott S. Snider
| | | Hi, | | | | | | Can someone pls suggest to me the best reflow temperature setting | | | for a force air convection oven. The details is as follow. | | | 1) Heller 1700s | | | 2) 12 zone---6 top and 6 bot | | | 3) Solder paste --- Qualitek 691
Electronics Forum | Mon Oct 12 01:17:00 EDT 2020 | SMTA-64386317
Hi, I am facing high fall out of microphone low sensitivity issues. This microphone is soldering thru SMT soldering with low peak temperature profile which peak at 232 DegC to 240 DegC and have skipped X-Ray inspection but still seeing fall out espec
Electronics Forum | Thu Oct 07 14:40:31 EDT 1999 | Carol Zhang
I have a board, 4 spacers needed to be soldered on the board first with the normal 62Sn37Pb alloy. Then, capacitors are manually soldered on the boards. The density of the board is quite high. If we wave soldered capacitors first, there will be no p
Electronics Forum | Tue May 13 08:59:13 EDT 2014 | gazelle
Hello davef - could it be you are confusing low thermal emf (Seebeck coefficient) with low temperature solder ? I am looking after solder wire and paste with low Seebeck coefficient - cadmium based alloy was OK but banned in europe due to RoHs direct
Electronics Forum | Mon May 12 15:08:53 EDT 2014 | davef
I've never used SAC405. Not for nothing ... Other low temperature solder alloys that you should consider are: * Sn42/Bi58 [138*C]: Alloy for low temperature applications. Attention should be paid to potential embrittlement issues and poor thermal fa
.gif)
winsouce.jpg)