Electronics Forum | Sun Oct 16 04:23:20 EDT 2005 | olas
I have a couple of questions about the SMEMA conveyor (standard 1.2); I posted the question to them but had no answer. SMEMA says: 5) Maximum gap. The maximum gap between the in-line machine track ends is 0.375� I would suppose this gap refers to th
Electronics Forum | Wed May 12 07:34:42 EDT 2004 | RLeonard
The standard machine is set from the factory at 7-9 degrees, 7 is the most standard, why are you considering the change? before doing any thing to the machine, first identify why? what type of defects are you seeing? I have found, depending on the t
Electronics Forum | Mon Jan 15 15:18:13 EST 2007 | jaimebc
We have an oMniflow 7 as well, and looking at the calibration procedure, it indicates that turning the pots ( total of 5 pots. 4 on the lower board and one on the upper board )fully counter-clockwise is the FIRST step of a series of tests. Then you w
Electronics Forum | Sun Feb 07 11:56:05 EST 2010 | mystkldy
Makes us wonder how well the connections on the > component match with the pads on the board. The pads are actually larger than the leads on the part, but I think we may have figured it out. We believe the conveyor vibration is causing it. When we
Electronics Forum | Tue Dec 22 13:56:20 EST 1998 | Michael Allen
Yes, you can adjust the board clamp speed by adjusting the flow control valve on both air cylinders (front and rear). You may also want to adjust the software delay for the conveyor so that it starts after the board is completely lowered. | Once
Electronics Forum | Sun Dec 20 00:29:45 EST 1998 | Hallj
Once the machine has finished placing all th parts is there a way to slow down the speed at which the machine lowers the board back to the conveyors? Or are added board supports the only option?
Electronics Forum | Mon Mar 24 15:28:27 EDT 2014 | yuran111
don`t have. give me please it. simens f5 with 6 segment head and IC-head. two conveyor. and if you can lower the entire inner hard drive, and then erased accidentally and slipped from siemens s27. thanks
Electronics Forum | Fri Jul 06 11:00:50 EDT 2007 | shrek
Krikies my friend. A good wave ogre will be able to look at a wave and tweak in a way to minimize contact length (by slowing the conveyor speed), thus improving peelback, and lower it to the bare minimum without disrupting it's backward and forward
Electronics Forum | Thu Feb 19 15:17:52 EST 1998 | Bipin Napal
Available immediately. Call Bipin at 416-385-0855 Make: Electrovert Model: 500 CLV Electrical: 440V, 3Phase, 60HZ Manufacturing Date: Dec 22, 1992, and upgraded in 1994 Physical Size: Length 205.5�, Width 55� Heating Zones : 10 Upper & 10 Lo
Electronics Forum | Thu Apr 07 12:02:08 EDT 2011 | grahamcooper22
Clearly you are above liquidus for too long so you can either increase conveyor speed or lower some zone settings. With your current recipe you don't mention the conveyor speed or the total profile length. Also ...are your max / min slopes really so
winsouce.jpg)
