Electronics Forum | Tue Jun 14 15:02:13 EDT 2022 | glasscake
Start with fundamentals: Disconnect, clean and reconnect all inner connections, bulk heads, ext. Disconnect, reconnect all connections at the controller. Check wiring harness for conductivity. Clean everything appropriately, lube ways, balls screws
Electronics Forum | Tue Jul 12 17:21:34 EDT 2022 | markhoch
It is possible. If the talcum powder mixes with the chain lubricant, it could gum everything up. Back a few years ago when I was running an SMT Quattro Peak, I was having an issue with the conveyor chain drive motor going into overload. We had to pul
Electronics Forum | Fri Feb 28 00:46:53 EST 2003 | MA/NY DDave
Hi I don't believe I have ever done this or seen it, yet maybe since there are some other lube processes. Ask the Amp Guy for any older App Notes. They used to have a lot. If I got this right you could put it on the board with an applicator that c
Electronics Forum | Fri Jun 04 09:30:43 EDT 2004 | gregf912
Grant, The Fuji chipshooters are built with the same mindset as the hydraulic presses and huge motor lathes that were the CP ancestors. The first Fuji CP was a modified motor lathe. They are solid. I can move a Fuji across the country and not have t
Electronics Forum | Tue Sep 19 14:52:40 EDT 2006 | bobpan
Grease every 2-6 months depending on the hours used. Dont overgrease.....and make sure you wipe off all excess grease after lubing because the grease always tends to get into the horseshoe sensors and then you will get motor error 4's untill you die!
Electronics Forum | Mon Jan 29 15:49:08 EST 2007 | rmitchell
Hi, Our Fuji CP65 nozzles are jamming in the up position. Mostly on caps and resistors, the .7mm (0402) and 1.0mm (0805) and 1.3mm (1206) sizes. They seem to be catching internally where the little peg slides down the slot. If you twist them they
Electronics Forum | Fri Oct 12 16:29:21 EDT 2007 | dyoungquist
When we bought our Heller reflow oven, the installation technician recommended using Oberon chain lube part # 680784(0) when we needed to purchase more oil for our chain. I just went to the oberonlube.com website and could not find that part number.
Electronics Forum | Tue Nov 06 07:37:02 EST 2007 | cyber_wolf
Does anyone out there have a method of cleaning CP6 shaft clutches that is "easier" ? I am not a fan of just pulling the shaft down and wiping it out. I like to take them apart and clean/lube them. It is a pain to get the crowns back on without rip
Electronics Forum | Sun Feb 03 11:10:13 EST 2008 | fastek
Pretty simple explanation really as it's happened to equipment I have sold and sent to Asia. If the paperwork on the importer's side of the transaction isn't up to snuff or they haven't paid off the right guy to get it in the country, the machine w
Electronics Forum | Wed Jul 02 16:58:40 EDT 2008 | jmelson
If these are similar to the earlier CSM feeders, there are several things to check. The cover plate that holds the tape on the sprocket can be adjusted slightly by eccentrics to accomodate thicker tapes. It the cover is too tight, there will be bin
