Electronics Forum | Tue Aug 08 16:49:41 EDT 2006 | darren
Chris Call Heller and get a new hard drive, then reload your software and start loading your recipes from your back up. That clicking noise, is it coming from inside the computer or the machine itself? Have you checked the power supply for the in th
Electronics Forum | Tue Dec 19 09:55:16 EST 2006 | bsteffen
If you call up Universal tech support at 1-800-842-9732, any of those guys or gal would email you the schematics to the MPUP feeder setup station.
Electronics Forum | Tue Jun 03 22:51:51 EDT 2008 | davef
Your circuit would consist of: * White noise generator * ~30Khz bandpass filter * Amplifier * Power supply You can find modules for these functions on the web. Good luck.
Electronics Forum | Thu Jul 17 08:36:21 EDT 2008 | steveliu
How did you convert the touch screen to the monitor and mouse combination? We had the same problem two years ago and tried to do the conversion, but ended up with a new DC/DC power supply card.
Electronics Forum | Thu Jul 17 09:21:29 EDT 2008 | proy
What did the DC to DC power supply card have to do with it, and where was it in the system? Pete
Electronics Forum | Thu Jul 17 17:20:39 EDT 2008 | steveliu
The screen we had is a Planar EL7768MS. There is a small DC/DC power supply board attahced to the back of the touch screen. That PS board was toasted and caused the failure of the screen. Steve
Electronics Forum | Thu Dec 18 21:09:06 EST 2008 | cadfamily
Welcome to http: //www cadfamily com supply EDA/CAM Learning Tutorial free download!!! For example:Mentor Graphic,Cadence,PowerPCB,PADS,ORCAD,AGILENG,ANSOFT,SYNOPSYS,ZUKEN,GENESIS,VA LOR,UCAM,PARCAM,VXWORKS,TONARDO,ACTEL,ACTIVE-HDL,FPGA ETC.
Electronics Forum | Tue Mar 10 14:21:45 EDT 2009 | smellew
yes this would be normal as that is when the servo power is supplied for servo lock, do you have a new servo amp?
Electronics Forum | Fri Apr 10 11:40:09 EDT 2009 | kenlowe
I have a Microjoin HCD-125 power supply for a resistance welder and it is not Welding, apparently I am not getting any welding current, Could this problem be with the programming of the unit or a fault wih same. if so how can I isolate the problem? T
Electronics Forum | Wed Jan 06 15:25:35 EST 2010 | wolverine
Any help would be appreciated We have a DEK 265 Screener that has been showing symtoms of a bad power supply. Is there a way to back up the hard drive and is an executive program needed in case the machine totally dies. Dave