Electronics Forum | Mon Oct 09 18:40:43 EDT 2006 | darby
Seeing you are already using Quad; I'd look at a Samsung CP-45V. I believe your feeders will be compatible but please cheeck to make sure! These are a six head, on the fly machine that will do just about anything you want apart from gripper applicat
Electronics Forum | Tue Oct 10 15:14:43 EDT 2006 | mfoster
Hi Phil, Most parts are still available for the Quad/Samsung QSA-30, through Dynatech (in North America). It is actually a single gantry, 3 spindle machine with rated speed of 14,000 cph. As with any used machine, it could be a great deal or a not
Electronics Forum | Mon Oct 09 07:50:22 EDT 2006 | quad
We currently run two Quad IVC's (we are very pleased with them) and two Versatronics for simple small volume batch work. We now need an additional machine capable of placing components at least three times as quickly as a IVC. We don't do anything ve
Electronics Forum | Mon Oct 09 13:36:30 EDT 2006 | ppminc
Phil, The QSA-30 was built by Sam Sung, Sold by Quad. Single Head 2 Nozzles around 11K CPH Quad does not support the machine but I believe you can get parts direct from Sam Sung. I am not sure if they have a registration fee. The QSA used Quad made
Electronics Forum | Thu Feb 10 14:56:50 EST 2005 | jimdugan
The Mydata machine is a very good high mix low volume machine. If you buy from Mydata you will be better supported, than if you buy from a broker. I would recommend you buy the newer My series machine. The TP machine was a good machine but the My ma
Electronics Forum | Mon Jun 22 01:49:27 EDT 2020 | vinitverma
I too would advise against converting a 3-phase machine to single phase. Eclipse is a single phase machine and not too difficult to find! It's a rugged machine and people still use them. Orion too is single phase but faster and less accurate than an
Electronics Forum | Thu Feb 10 13:59:35 EST 2005 | bradb
Grant, Thanks for the info. If you are getting rid of your my Data machines please let me know. We are looking at low volume capabilities and your equipment will fit that bill. Please call if your interested in selling the machine. Regards, Brad
Electronics Forum | Fri Feb 11 15:50:51 EST 2005 | Grant
Hi, We are looking at selling the machine in mid April, May time frame. We are selling the machine, all feeders etc. But it's located in Australia, so a bit hard to ship to most locations. If your interested, please email grantpetty@blackmagic-desig
Electronics Forum | Tue Jun 23 21:48:06 EDT 2020 | jmelson
I don't know much about Essemtec, I have been looking at Neoden a little. At least the Neoden is not in any way in the same class as machines like Assembleon or Samsung. I did download the manual for a Samsung CP45FV NEO, and the programming side o
Electronics Forum | Sat Jan 29 04:59:02 EST 2005 | Grant
Hi, MYDATA's are ok for lower volume, and they are very flexible. If you only have 1 or 2 trays of components and are on a tight budget, then you can even place the trays on the Y wagon behind the PCB so you can get away without the tray wagon. Al
.gif)
winsouce.jpg)