Electronics Forum | mgrimes |
Fri Jul 15 16:17:25 EDT 2011
Electronics Forum | Mon Jul 11 07:40:11 EDT 2016 | spoiltforchoice
I don't know your machine but you are looking at the most likely areas. Some machines define a placement pressure, other may define an overtravel to make sure the device is firmly placed on the board. There are usually also timings for when the vacuu
Electronics Forum | Thu Aug 30 21:25:37 EDT 2001 | davef
Oooo, nice machine. For chuck repair, try: Mt Sterling Industries POBox 670 Mt Sterling KY 40353 606.498.1015fax4156. This is not rocket science. A local machine shop could probably do just as nice of a job. For newer chucks, try the brokers list
Electronics Forum | Thu Mar 04 07:44:22 EST 2010 | cot628
The company that I work for is looking for a reliable Xray machine. Has anyone bought or used an Inspex Xray system?
Electronics Forum | Mon Jun 13 10:23:06 EDT 2011 | davef
Yes, it has. It's always fun to watch the smart guy guys work.
Electronics Forum | Tue Jun 14 23:36:00 EDT 2011 | vms
I guess you do what a lot of companies do, buy the ones that don't work. And then spend more money trying to fix them. I've seen this pratice go on for years.
Electronics Forum | Tue Jul 12 10:40:27 EDT 2016 | leeg
Brad, have you got any calibration jigs with the machine? This could also be down to laser offset or laser scaling which are both calibrated with different jigs. Where are you based?
Electronics Forum | Sun Jul 10 15:29:56 EDT 2016 | bradholland
hi everyone, new user and noob here. I've spent the last week getting acquainted with my juki 740, being totally new to placement etc it's been fun to learn! I've now gotten to a stage where everything is setup in the machine for my board and is p
Electronics Forum | Mon Jul 11 10:48:48 EDT 2016 | mnorthey
I have experienced this problem on a number of different machines and have found that it has been one bad nozzle causing the problem. We run Juki 3010 and 3020 and occasionally we have had similar problems. One question, is it bad placements on all 6
Electronics Forum | Mon Jul 11 10:59:50 EDT 2016 | mnorthey
Other problems on previous machines that we have experienced is that there was not enough board support under the panel or that the panel thickness was inaccurate. Both situations can cause parts to bounce off the PCB or not to be pushed into the pas