Electronics Forum | Thu Apr 26 11:21:26 EDT 2007 | slthomas
Question...when the machine said something was wrong, was it reading something wrong (false failure), or was there a true descrepancy but not one that resulted in a bad connection (bridge or insufficient)? Also, did you perform a DOE on the process
Electronics Forum | Tue Jan 10 02:17:29 EST 2017 | soldertraining
Hi ! I am also looking for the same and I am aware of this little like the -selective solder machines are generally cheaper to run due to the reduced amount of flux and solder being used and it’s possible to use a solder with no silver content and st
Electronics Forum | Mon May 16 16:40:50 EDT 2005 | russ
Fred, give us a quickie at what you will be soldering Single sided thu hole, double sided SMT, both, lead pitches and protrusions, Flux type, and such. Buying a used wave can be tricky and the more info up front the better we will be able to tell yo
Electronics Forum | Wed May 16 10:37:34 EDT 2001 | davef
Similar to my response to your previous posting on this topic dated 5/8/01, things to try are: 1 Contact your non-supplier [Streckfuss] using the contact points at http://www.streckfuss.com/wave_soldering.htm, obtain source drawings for components o
Electronics Forum | Thu Sep 02 16:55:04 EDT 1999 | Brian
You use MCS computers to transmit programs/data to machines | --> MCSs are getting old, so you would like to use F4G or FujiCam just because you could use a standard 486/Pentium | --> But you still like your current programming SW (obviously not MCS/
Electronics Forum | Thu Sep 02 12:27:54 EDT 1999 | stefano bolleri
You use MCS computers to transmit programs/data to machines --> MCSs are getting old, so you would like to use F4G or FujiCam just because you could use a standard 486/Pentium --> But you still like your current programming SW (obviously not MCS/F4G/
Electronics Forum | Fri Mar 24 15:20:27 EST 2000 | Chris McDonald
I have recently purchased a Tape and reel machine from V-Tech. We are using Presure Sensitive tape and we are not geting good results. Anything bigger that a SOIC14/16 gives us trouble. The cover tape will pull off on the feeder and we will lose part
Electronics Forum | Tue Nov 15 19:31:54 EST 2005 | eeltec
>I/OPERATION ==> >1/RUNNING ==> but any command that I try gives an E100 error and in the left side of the monitor a square with: Conditions Initialized Waiting Emg stop (in red) org incmp (in red) Interlock (in red) data comp Use Vac
Electronics Forum | Wed Mar 04 10:05:13 EST 2020 | dontfeedphils
In a past life I used a Swam Blaster from Crystal Mark with the media from them as well. I used it on Humiseal 1A31 and 1B31 (I think those were the products, it's been a little while). This machine and material were awesome IMO. Made CC removal a
Electronics Forum | Mon Oct 30 22:22:08 EDT 2023 | cbeneat
We've used PVA (Precision Valve Automation) for years. Programming is straight forward. Can do simple areas to more complex, depending on valve choices and complexity of what you need to spray. We use a standard pray valve as well as a syringe. We da