Electronics Forum | Tue Dec 07 00:13:00 EST 2004 | saiwong
I have a problem that our JOT convoyors & loader cannot connect the Fuji machine. Also, I wondered how can I get the support from JOT.
Electronics Forum | Tue Apr 13 14:56:22 EDT 2010 | charlesyeh_wellex
Hi: Did any one know about how to connect boardFLO to Fuji CP machine? I did not have communication cable between both two machine. Thank you
Electronics Forum | Tue Oct 03 09:23:55 EDT 2006 | kenscj
We are encountering BGA solder open connection. At Functional Test, the board failed. Debug guy diagnosed this BGA open connection (2 locations), by using multimeter. Under 5DX inspection, there is connection. Take the board for localised reflow at
Electronics Forum | Wed Apr 21 14:38:30 EDT 2010 | remullis
Newer Universal Conveyors use 4 wire smema and FUJI should accomodate this protocol in its config screens. Old Universal Conveyors and some machines used SMPI (forget how many wires), You can purchase the 4 wire smema cable from UIC and conversio
Electronics Forum | Wed Apr 10 03:46:29 EDT 2019 | oxygensmd
Depends on what machine you want to get. Linux OP used on S13-S15-S20-F3-F4 for a time but they changed to WinXP - after '96. The new software with WinXp is more stable as the Lunix version. The Linux version was really sensitive of LinePC-StationPC
Electronics Forum | Fri Sep 19 13:22:33 EDT 2008 | evtimov
Hi, if it is for all your products, for me it looks like a camera cable or camera problem. You are loosing connection and get the message. FFFC looks like a fatal error. If it is only one product, play with the lighting and treshold. Regards, Emi
Electronics Forum | Thu Apr 26 11:21:26 EDT 2007 | slthomas
Question...when the machine said something was wrong, was it reading something wrong (false failure), or was there a true descrepancy but not one that resulted in a bad connection (bridge or insufficient)? Also, did you perform a DOE on the process
Electronics Forum | Fri Nov 18 02:42:46 EST 2005 | vinitverma
Greg, I recently faced this problem at a customer though the machine was Topaz X but the problem was same. So I suggest you first check if the GOOD LED is ON on the Servo card down in the MCX box. Also check the same GOOD LED on the System board in
Electronics Forum | Wed May 15 05:44:04 EDT 2019 | peterchan
1、YSVJ-650B three-group multi- blades cutting machine, multiple sets of tools run at the same time, split the whole piece at one time, greatly improve production efficiency; multiple sets of tool design ensure that the split plate effect is not defor
Electronics Forum | Thu Feb 28 11:02:31 EST 2013 | hegemon
1. Read the manual. It's pretty good, and an easy read. Most tech guys could read the manual and have a good start. 2. Call Mirtec, they should connect you with a local rep. who may or may not have some machine knowledge. They may want $ if the m
