Electronics Forum | Mon Jun 29 12:39:07 EDT 1998 | Coogan
GEM (Generic Equipment Model) and SECS (Semiconductor Equipment Communications Standard)were developed to provide an standard communications protocal for equipment of different manufacturers. However, although the machines connected through GEM "tal
Electronics Forum | Wed Jan 27 08:31:13 EST 2016 | oxygensmd
You need to connect the MC (machine controller), SC (station controller) and the LR (line computer / linie rechner) to same network. The Siplace's network is really strange because this 3 machine will communicate together. You can give the right IPs
Electronics Forum | Mon Dec 06 21:07:36 EST 2021 | victorzubashev
Hi, you have flickering that affects all AC power in the machine (PC is also connected to the AC line (after step down transformer)), correct? Do you intermittently/randomly lose power in all machines units(MC/PS/Servo)? If I understood you correctly
Electronics Forum | Wed Jul 12 17:17:04 EDT 2006 | fordf1502004
I want to thank you for your help. after further investigation into the panasonic machine one our technicians was able to fix the issue. The panasonic machine uses a 5 volt signal and normal smema uses a 24 volt signal. To make these 2 machine talk t
Electronics Forum | Wed Nov 29 10:48:37 EST 2006 | bas Rottier
Hello, I'm looking for a protocol description of the SMPI interface (we would like to connect a SMPI machine to a SMEMA machine). Does anybody have description of signals (electrically) + waveforms + pin-layout + connectortype? THanks Regards bas.r
Electronics Forum | Mon Nov 17 06:27:50 EST 2014 | garym4569
In the program editor on the machine, you can output a text file of the production data. You can select to output placement data, component data, and/or feeder setup for the product currently loaded on the machine. You can also do the same in the H
Electronics Forum | Thu Oct 09 17:50:39 EDT 2014 | joe98375
Greetings, We have a very old IC insertion machine mentioned in the subject line. The system seems to have lost all communication between the computer and the machine. The connections between them are good and I do not see any signs of electrical da
Electronics Forum | Mon Dec 01 18:57:26 EST 2014 | rodrigo
Hi all, I partially installed the F4G files in a Windows XP machine. Partially because this machine is not connected to any production machines. So I installed the library, programmer group and the cp6 optimizer. The Data Manager works. I can see al
Electronics Forum | Tue Jun 13 07:22:50 EDT 2017 | emeto
If these are snuggers(locking PCB from the side) that means one or two of these handles move the Z table up and down. Is there any air going to this machine that you diddn't connected? Or your pins underneath might be adjustable.
Electronics Forum | Thu May 23 11:36:50 EDT 2024 | wippsen
As I mentioned before, you probably have view only access set up. create a completely new VNC shortcut. Do not use existing shortcuts. Connect to the machine's IP address and use "r" or "c" as the password.